Whirlpool EHD251CMWR0 warranty Using your refrigerator, Setting Controls, Power Saving Control

Using your refrigerator

Air Outlet

Air Control

OFFON

Off Setting

Helps Save Energy

Power-Saving	Control	Temperature
		Control	Dial

Setting	the	Controls.
The Temperature			Control	and	Power Saving Control ore on a con-
sole inside	the refrigerator.			The	Air Control			is in the	freezer.	To start the
refrigerator,	turn		the TEMP CONTROL			dial	to 3 and		the AIR	CONTROL
dial to 3. These are normal settings.
It takes time		for your refrigerator				to reach		proper storage temper-
atures When		you	first turn	it on,	it will	run	continuously		until	the interior

gets properly cold. Before loading with food, be sure the refrigerator has cycled at least once (turned on, turned off, and on again). Controls will be set about right if your milk or juice is as cold as your family likes it, and when ice cream is firm.

The control console has directions for raising or lowering the tem- peratures, if needed.

Do not store to// items in front of the co/d air outlet in the freezer.

Blocking the outlet will keep the cold air from the refrigerator.

Power Saving Control.

The Power Saving Control inside your refrigerator controls electric heaters These heaters help prevent moisture from forming on the outside of the refrigerator when humidity is high. Use the OFF setting when humidity is low to help save electricity. Use ON only if moisture forms on the outside of the refrigerator.

Tilt the Front; Lift the Back

Removing Non-Adjustable Shelves.

To remove a shelf, lift up the front. Then lift up at the back. To replace it, put the rear notches onto the shelf supports. Lower the front into place.

Adjusting the Shelves.

Arrange your gloss refrigerator shelves to suit yourself. Be careful. The shelves ore heavy.

To remove Q shelf, tilt up at the front. Then lift up at the back. To replace it, keep it tilted. Guide the rear hooks into the slots in the shelf bracket. Lower the front.

Three Servo-Door shelves can be adjusted to hold tall bottles and short jars. To move a shelf, lift it up and out. To replace it in a new position, insert the shelf hooks into guides on both sides and push down.

Use the bottom shelf for toll bottles. A guard on that shelf helps keep them from tipping when the main door is opened or closed.

4