Kenwood XD-A700 Select the source to be recorded, CD 0, Start recording, To pause recording

Selection of the reverse mode

REV.MODE

Each press switches the modes as follows.

1 “[” ... Both sides are played back (recorded), and then the tape stops.

2“Ó” .. Both sides are played back endlessly. (The tape stops after recording onto both

sides.)

3“Ò” .. Only one side is played back (recorded), and then the tape stops.

To pause recording

REC/ARM

ÖPressing the key pauses recording after leaving a non-recorded space of about 4 seconds.

ÖIf the key is pressed again in less than 4 seconds after it has been pressed, recording resumes from that instant.

Let's record

XD-951/A900/A700 (En)

Selection of DOLBY NR (Noise Reduction)

The Dolby NR system minimizes the hiss noise heard when playing tape. When playing a tape prerecorded with Dolby NR ON, be sure to set the DOLBY NR ON for playback.

	Lit when “DOLBY NR” is ON.
DOLBY NR	TAPE B 0
	NR

Each press switches the modes as follows.

1 “Ù NR” ON DOLBY NR is used.

2“Ù NR” OFF ............. DOLBY NR is not used.

29

Preparation section

Basic

4.Select the source to be recorded.

	The input source component to be recorded should be displayed.
	1 TUNER (Radio)
4	2 CD		CD 0 1	0 0 0
	3 TAPE
	4 AUX (External input)		1 2 3
	(AUX INPUT LEVEL adjustment u)
		ÖWhen the CD input is selected and if a disc has
		been set in the CD player, its playback starts
Select an input source other than “TAPE”.		immediately.

5.Start recording.

REC/ARM	1Play (or tune) the input source to be	CD	0 1 0 1 2
	recorded.
	2Start recording.	1	2	3

5 Lights

ÖRecording stops automatically when the tape side(s) to be recorded have been fully recorded.

section

Application section

Knowledge sections