Kenwood XD-A900, XD-951, XD-A700 instruction manual Di R, Copying tape Tape dubbing, To stop dubbing

Copying tape (Tape dubbing)

The contents of the tape in deck A can be copied onto the tape in deck B.

Let's record 31

XD-951/A900/A700 (En)

Load tapes in the decks.

1Select the “TAPE” input.

INPUT

2Press the stop key.

3Select “[” (double-side recording) or “Ò” (one-side recording).

REV.MODE

4Press the DUBBING key.

DUBBING

5Select “TAPE DUBBING” and press the SET key.

1. Select. 2. Press SET.

MULTI

CONTROL

SET

6Use the same tape transport direc- tions.

(1)Select the transport direction of deck A.

1. Select. 2. Press SET.

MULTI

CONTROL

SET

(2)Select the transport direction of deck B.

MULTI

CONTROL

7Start dubbing.

ENTER

Playing tape A A Recording tape

						Preparation section
		CD RECORD
		CD EDIT
		CD PGM RECORD
		TAPE DUBBING				Basic
				TAPE	D U B B I
				(TAPE DUBBING)		section
				Scrolled display
ÖWhen recording is started, the tape will be transported in the direction
	selected in this step.
			Check the tape transport direction
			indicators.
		A DIR FWD		A DI R	F W D	Application
		A DIR RVS
		B DIR FWD
		B DIR RVS				section
		RETURN
ÖBy selecting “RETURN” and pressing the ENTER key, the operation
	returns to the previous step so the current step can be restarted.
ÖDubbing ends automatically when the side(s) to be dubbed has been
	completed.
To stop dubbing
				REC/ARM		Knowledge
	ÖThe deck B will stop after creating a non-recorded portion of about
						sections
		4 sec, and then the deck A will stop.
	ÖDubbing can also be stopped by pressing the stop (7) key. Note that
		the non-recorded space is not created in this case.

The DOLBY NR key is not active in dubbing mode. The tape recorded on deck B assumes the same Dolby NR condition as the tape played on Note deck A.