Dynaudio BM9S owner manual Controls and connections

➊

➋

➐

➑

➒

➑

➒

Before operation

Controls and connections

➊POWER ON/OFF

Main power switch (to switch the subwoofer manually on and off). LED shows operation mode:

•red = subwoofer switched on and in mute mode

•green = subwoofer is activated

➋AC IN

Mains power input.

➌Gain

Subwoofer volume level.

➍SUB Lowpass

Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.

➎Phase

Phase setting: phase can be set to 0° or 180°.

➌➏ Mode

Subwoofer operation mode LFE or Slave.

•LFE: setting for normal use and Master use.

•Slave: setting for second and all following subwoofers.

➍

➐LFE IN/OUT

• LFE/Slave IN: input for LFE signal.

➎• Slave OUT: output to next subwoofer if installed.

➑SAT/SUB IN

➏Input for full bandwidth signal. This signal will be processed according to the SAT Highpass setting and provided at the SAT/SUB OUT.

➒SAT/SUB OUT

Output for satellite system to be connected. This signal is processed according to the SAT Highpass setting.

➓SAT Highpass

Allows cutting off low frequencies of the signal provided at the SAT/SUB OUT.

•Flat: signal is not processed

•60: cut-off frequency at 60 Hz

•80: cut-off frequency at 80 Hz

➓	Terminal pinout ➐, ➑, ➒
	1 = 0
	2 = +
	3 = –

Dynaudio Acoustics BM9S 5