Dynaudio BM9S owner manual Connecting the subwoofer, Subwoofer inputs, LFE/Slave, Sat/Sub

Before operation

Connecting the subwoofer

CAUTION

DAMAGE OF DEVICE DUE TO IMPROPER CONNECTION!

XSet the mains power switch to OFF before connecting the BM9S.

XOnly switch the subwoofer on (mains power switch to ON) after all connections and set up steps have been properly completed.

LFE/Slave IN SAT/SUB IN

LFE

Mode

Slave

+

SUBSAT

Lowpass Highpass

+

Gain

Phase

+

Subwoofer inputs

The BM9S provides two different signal inputs:

LFE/Slave IN

This input allows the LFE (Low Frequency Effect) channel to be connected. The signal is:

•reproduced by the subwoofer

•routed to the Slave OUT for a second subwoofer to be connected. The SUB Lowpass control has no impact on this input.

SAT/SUB IN

This input allows the connection of a full bandwidth signal.

The signal is:

•reproduced by the subwoofer,

•routed to the SAT/SUB OUT terminals. Low frequencies are cut-off according to the SAT Highpass setting,

•routed to the Slave OUT for a second subwoofer to be connected. High frequencies are cut-off according to the SUB Lowpass setting.

Slave OUT SAT/SUB OUT

Subwoofer

6 Dynaudio Acoustics BM9S