3Use more of your TV
Pause TV
What you can do
While you watch a digital channel, you can pause a programme to answer a phone call or to have a break. The broadcast is stored on a USB hard drive that is connected to the TV. You can resume playback of the programme at any time.
Note:
∙You can pause a programme for a maximum of 90 minutes.
What you need
∙Tune your TV to receive digital channels. See Change your TV settings > Channels > Automatic installation
(Page 34).
∙Connect a USB 2.0 compatible hard drive with a minimum capacity of 4 GB and a minimum transfer speed of 30 megabits per second. For optimal performance, use a hard drive with 32 GB of disk space.
Install USB hard drive
To pause TV, you must connect a USB hard drive to the TV and format it.
If the TV does not recognise the USB hard drive, use a PC to format it to NTFS or FAT32 system, then try again.
Caution:
∙TP Vision is not responsible if the USB hard drive is not supported, nor is it responsible for damage to or loss of data in the device.
∙Formatting removes all data from the connected USB hard drive.
EN 22
∙The USB hard drive is formatted exclusively for this TV. Keep it permanently connected to the TV. You cannot access the contents of the USB hard drive from another TV or PC.
∙Do not overload the USB port. If you connect a USB hard drive device that consumes more than 500mA power, make sure that it is connected to its own external power supply.
Note:
∙Make sure that the TV and the USB hard drive are switched off.
∙While you are formatting the USB hard drive, do not connect other USB devices to the TV.
1.Connect the USB hard drive directly to the TV, or if you intend to connect other USB devices in future, connect the USB hard drive through a USB hub.
2.Switch on the TV and the USB hard drive, if it has an external power source.
3.Switch to a digital TV channel.
4.Press to start formatting the USB hard drive.
5.Follow the onscreen instructions to complete the formatting process. Warning: The formatting process may take some time. Do not switch off the TV or disconnect the USB hard drive until this process is complete.