Classe Audio CT-M600, CA-M600 owner manual Class

Page 2

NOTICE

All of us at Classé take extreme care to ensure that your purchase will remain a prized investment. We are proud to inform you that all Classé components have been officially approved for the European Community (CE) mark.

This means that your Classé product was subjected to the most rigorous manufacturing and safety tests in the world. The CE mark certifies that your purchase meets or exceeds all European Community requirements for manufacturing consistency and consumer safety.

This equipment has been tested and found to comply with the limits for a

Class

B digital device,

pursuant to Part 15 of the

FCC Rules. Operation is subject to the following two conditions: (1) This

device

may not cause

harmful interference, and (2)

This device must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna;

Increase the separation between the equipment and the receiver;

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;

Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

The information contained in the manual is subject to change without notice. The most current version of this manual will be posted on our web site at http://www.classeaudio.com.

Classé marks the “CE” symbol indicating compliance of this device with the EMC (Electromagnetic Compatibility) and LVD (Low Voltage Directive) standards of the European Community.

Classé complies with the European Parliament and Council Directive 2002/96/EC concerning Waste Electrical and Electronic Equipment (WEEE). This product must be appropriately recycled or processed in accordance with these directives. Consult your local waste disposal authority for guidance.

Classé products are designed and manufactured to comply with the Restriction of Hazardous Substances (RoHS) as stated in the European Parliament and Council Directive 2002/95/EC.

2

Image 2
Contents CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Word about installation Welcome to the Classé familyUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Special Design Features Extensive listening tests Extraordinary longevityRobust protection Front Panel Standby button & LED indicatorFlashing blue on power-up = On dim redPage Rear Panel Balanced XLR InputSingle-Ended RCA Input Speaker OutputsClassé CAN-Bus Control Ports IR Input and OutputUSB Control Port DC Trigger Input and OutputRS 232 Control Port AC Mains InputPage 32 X 9/16 philips pan head screws InstallationCT-M600 stand-alone installation instructions 32 X 3/4 screws Make your speaker connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Double-check all your connectionsClassé Delta or CT Series Products Install the front panel CT-M600 onlyCAN-Bus Category 5 Network CablesAny combination of models in any order Using CAN-Bus CAN-Bus shared features Following CAN-Bus features are shared by all modelsFollowing CAN-Bus features are model-specific PlayLinkAmp info Event log Care and Maintenance No sound, and Standby LED is blinking red TroubleshootingNo sound, and Standby LED is not lit Amplifier keeps shutting offAC mains fuse is blown Standby LED is flashing quicklySpecifications Dimensions CA-M600CT-M600 Page North America 514