Classe Audio CA-M600, CT-M600 owner manual 32 X 3/4 screws

Page 19

Important!

Optional accessory feet can be purchased and installed as follows.

1b. Install (4) accessory feet (FC90902) and secure with

(8) 6-32 X 3/4 screws.

Tighten to

8.5 in-lbs (0.96 N-m)

Install (2) securing brackets when using the CT-M600 in a stand-alone (non-rack-mount) installation.

2.Install left and right faceplate securing brackets (L7326 for CT-SSP and CT-AMPS, and L7909 for CT-5300) secure with (4) 8-32 X 3/8 philips pan head screws.

Tighten to

5.0 in-lbs (0.56 N-m)

Image 19

Contents CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Welcome to the Classé family Word about installationUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Extensive listening tests Extraordinary longevity Special Design FeaturesRobust protection On dim red Standby button & LED indicatorFlashing blue on power-up = Front PanelPage Balanced XLR Input Rear PanelSpeaker Outputs Single-Ended RCA InputIR Input and Output Classé CAN-Bus Control Ports AC Mains Input DC Trigger Input and Output RS 232 Control Port USB Control PortPage CT-M600 stand-alone installation instructions Installation32 X 9/16 philips pan head screws 32 X 3/4 screws Double-check all your connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Make your speaker connectionsCategory 5 Network Cables Install the front panel CT-M600 onlyCAN-Bus Classé Delta or CT Series ProductsAny combination of models in any order Using CAN-Bus Following CAN-Bus features are shared by all models CAN-Bus shared featuresPlayLink Following CAN-Bus features are model-specificAmp info Event log Care and Maintenance Amplifier keeps shutting off TroubleshootingNo sound, and Standby LED is not lit No sound, and Standby LED is blinking redStandby LED is flashing quickly AC mains fuse is blownSpecifications CA-M600 DimensionsCT-M600 Page North America 514