Classe Audio CT-M600, CA-M600 owner manual Any combination of models in any order

Page 22

22

The diagrams below illustrate how to connect the CAN-Bus hardware.

Any combination of models in any order.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

For any system with SSP-300 or SSP-600.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.

Image 22

Contents CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Word about installation Welcome to the Classé familyUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Special Design Features Extensive listening tests Extraordinary longevityRobust protection Front Panel Standby button & LED indicatorFlashing blue on power-up = On dim redPage Rear Panel Balanced XLR InputSingle-Ended RCA Input Speaker OutputsClassé CAN-Bus Control Ports IR Input and OutputUSB Control Port DC Trigger Input and OutputRS 232 Control Port AC Mains InputPage CT-M600 stand-alone installation instructions Installation32 X 9/16 philips pan head screws 32 X 3/4 screws Make your speaker connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Double-check all your connectionsClassé Delta or CT Series Products Install the front panel CT-M600 onlyCAN-Bus Category 5 Network CablesAny combination of models in any order Using CAN-Bus CAN-Bus shared features Following CAN-Bus features are shared by all modelsFollowing CAN-Bus features are model-specific PlayLinkAmp info Event log Care and Maintenance No sound, and Standby LED is blinking red TroubleshootingNo sound, and Standby LED is not lit Amplifier keeps shutting offAC mains fuse is blown Standby LED is flashing quicklySpecifications Dimensions CA-M600CT-M600 Page North America 514