Classe Audio CT-M600, CA-M600 owner manual Specifications

Page 30

30

Specifications

All tests un-weighted and 500kHz measurement bandwidth (except SNR).

n

Frequency response

1Hz – 80kHz, -3dB

 

 

10Hz – 155kHz (+0/-3.0dB)

n

Output power

600W rms into 8Ω (27.8 dBW)

 

Harmonic Distortion

1200W rms into 4Ω (27.8 dBW)

n

<0.002% @ 1kHz balanced

 

Peak Output Voltage

<0.004% @ 1 kHz single ended

n

240V peak to peak, 80V rms no load

 

 

220V peak to peak, 73V rms into 8Ω

n

Input Impedance

50kΩ balanced / single ended

n

Voltage gain

29 dB balanced / single ended

n

Input level at clipping

2.86V rms balanced / single ended

n

Intermodulation Distortion

>100dB below fundamental into

 

 

8Ω balanced / single ended

 

 

>90dB below fundamental into

 

 

4Ω balanced / single ended

n

Signal-to-noise ratio

-120dB at peak output into 8Ω

 

 

Measurement Bandwidth: 22kHz

n

Output Impedance

0.03Ω @ 1kHz

n

Standby power consumption

<1W @ 230V

n

Rated power consumption

823W @ 1/8th power into 8Ω

n

Overall Dimensions

CA-M600 Width: 17.50” (444mm)

 

CT-M600 Width (including faceplate): 19” (483mm)

 

CT-M600 Width (excluding faceplate): 17” (432mm)

 

CA-M600 Depth (excluding connectors): 17.52” (445mm)

 

CT-M600 Depth (excluding connectors): 18.625” (473 mm)

 

 

CA-M600 Height: 8.78” (223mm)

 

Gross weight

CT-M600 Height: 6.97” (177mm)

n

CA-M600: 100lbs (45.36 kg)

 

Net weight

CT-M600: 109lbs (49.50kg)

n

CA-M600: 88lbs (39.92 kg)

 

Mains voltage

CT-M600: 89lbs (40.5kg)

n

Specified on rear panel

For more information, see your Classé dealer, or contact:

B&W Group Ltd.

5070 François Cusson

Lachine, Quebec

Canada H8T 1B3

Telephone

+1 (514) 636-6384

FAX

+1 (514) 636-1428

Internet:

http://www.classeaudio.com

email:

cservice@classeaudio.com

Classé and the Classé logo are trademarks of B&W Group Ltd., Worthing U.K. All rights reserved. AMX® is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved. Crestron™ is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved. Control 4™ is a trademark of Control 4 Corporation of Saltlake City UT. All rights reserved.

Image 30
Contents CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Word about installation Welcome to the Classé familyUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Special Design Features Extensive listening tests Extraordinary longevityRobust protection Front Panel Standby button & LED indicatorFlashing blue on power-up = On dim redPage Rear Panel Balanced XLR InputSingle-Ended RCA Input Speaker OutputsClassé CAN-Bus Control Ports IR Input and OutputUSB Control Port DC Trigger Input and OutputRS 232 Control Port AC Mains InputPage Installation CT-M600 stand-alone installation instructions32 X 9/16 philips pan head screws 32 X 3/4 screws Make your speaker connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Double-check all your connectionsClassé Delta or CT Series Products Install the front panel CT-M600 onlyCAN-Bus Category 5 Network CablesAny combination of models in any order Using CAN-Bus CAN-Bus shared features Following CAN-Bus features are shared by all modelsFollowing CAN-Bus features are model-specific PlayLinkAmp info Event log Care and Maintenance No sound, and Standby LED is blinking red TroubleshootingNo sound, and Standby LED is not lit Amplifier keeps shutting offAC mains fuse is blown Standby LED is flashing quicklySpecifications Dimensions CA-M600CT-M600 Page North America 514