Classe Audio CA-M600, CT-M600 Front Panel, Standby button & LED indicator, On dim red, On blue

Page 11

CA-M600

1

CT-M600

Front Panel

1Standby button & LED indicator

The front panel Standby button will toggle the amplifier between operate, its fully operational state, and a standby mode that leaves the amplifier off, yet ready to respond to system commands via any of the supported control options (e.g. IR input, DC trigger, CAN-Bus, or RS-232).

The current state of the amplifier is indicated by theLED indicator in the

Standby button. The state of this LED indicates the following:

•	on (dim red)	=	standby
•	flashing blue (on power-up) =		initialization
•	on (blue)	=	operate
•	flashing (after power-up)	=	AC mains voltage out of range
•	flashing (combined red/blue)	=	the air intake filter needs to be cleaned
•	slow flashing red	=	protection circuit(s) engaged

11

Image 11

Contents CA-M600 / CT-M600 600W Monaural Amplifier Class Important Safety Instructions Contents Welcome to the Classé family Word about installationUnpacking and Placement Operating voltage Warm up/break-in period Please read this manual… Extensive listening tests Extraordinary longevity Special Design FeaturesRobust protection On dim red Standby button & LED indicatorFlashing blue on power-up = Front PanelPage Balanced XLR Input Rear PanelSpeaker Outputs Single-Ended RCA InputIR Input and Output Classé CAN-Bus Control PortsAC Mains Input DC Trigger Input and OutputRS 232 Control Port USB Control PortPage 32 X 9/16 philips pan head screws InstallationCT-M600 stand-alone installation instructions 32 X 3/4 screws Double-check all your connections Configure your amplifier turn-on delay/amp numberMake your preamp/processor connections Make your speaker connectionsCategory 5 Network Cables Install the front panel CT-M600 onlyCAN-Bus Classé Delta or CT Series ProductsAny combination of models in any order Using CAN-Bus Following CAN-Bus features are shared by all models CAN-Bus shared featuresPlayLink Following CAN-Bus features are model-specificAmp info Event log Care and Maintenance Amplifier keeps shutting off TroubleshootingNo sound, and Standby LED is not lit No sound, and Standby LED is blinking redStandby LED is flashing quickly AC mains fuse is blownSpecifications CA-M600 DimensionsCT-M600 Page North America 514