Classe Audio CA-D200 owner manual Any combination of models in any order

Page 17

The diagrams below illustrate how to connect the CAN-Bus hardware.

Any combination of models in any order.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

For any system with SSP-300 or SSP-600.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

NOTE: Daisy chain may need to be terminated with CAN-Bus Terminator.

17

Image 17

Contents CA-D200 Two-Channel Amplifier Class Important Safety Instructions Contents Welcome to the Classé family Word about installationUnpacking and Placement Warm up/break-in period Please read this manual… Special Design Features Front Panel Standby button & LED status indicatorOn red Flashing blueBalanced XLR Input Rear PanelSpeaker Outputs Single-Ended RCA InputClassé CAN-Bus Control Ports IR Input and OutputRS 232 Control Port DC Trigger Input and OutputRJ-45 RJ-45 DB9 female adaptorUSB Port AC Mains InputMake your preamp/processor connections InstallationConfigure your amplifier turn-on delay/amp number Make your speaker connections CAN-BusDouble-check all your connections CAN-Bus will allow a Classé touchscreen toCategory 5 Network Cables Classé CAN-Bus Equipped ProductsCAN-Bus equipped components in your system CAN-Bus Terminator SSP-300 & 600 CAN-Bus Interface BoxFor any system with SSP-300 or SSP-600 Any combination of models in any orderFollowing CAN-Bus features are shared by all models CAN-Bus shared featuresPlayLink Following CAN-Bus features are model specificAmp info Event log Care and Maintenance No sound, and Standby LED is not lit TroubleshootingNo sound, and Standby LED is blinking red Protection circuitry has been engagedMains voltage 100-120VAC Fuse type AC mains fuse is blownRating 3AH Mains voltage 200-240VAC Fuse type Rating 15AHSpecifications CA-D200 DimensionsPage North America 514 François Cusson Lachine, Quebec+1 514 +1 514 636-1428 fax