Orion Car Audio 1200D, 600D, 2500D manual Adjusting the Sound of the System

Page 17

Adjusting the Sound of the System

Once you have checked the system's operation, adjust the sound of the system. Adjusting the sound of the system is accomplished by setting the level controls and adjusting the internal crossovers.

Step 1 Turn the signal source volume control all the way down. Set any tone con- trols to their flat or defeated positions. This includes the loudness control.

Step 2 Turn the level controls of the amplifier to their minimum positions.

Step 3 Choose music with high dynamic content that you like, with which you are familiar, and will be used most often in the system.

Step 4 Turn the source unit's volume control up to its highest undistorted output level. If you lack test equipment, this point occurs between 3/4 to full volume depending on the quality of your source unit. Listen for any audible distor- tion. If any distortion is audible, reduce the volume of the source unit until you have an undistorted output. Leave the volume control at this position during your system tuning.

Step 5 While listening to your chosen dynamic music, turn up the level control cor- responding to the midrange output until you hear slight distortion and turn the level control back slightly for an undistorted output. Depending on your system, the midrange and tweeter output may be on the same output chan- nels.

Step 6 Turn up the level control corresponding to the tweeter output until you hear slight distortion and turn back the level control slightly for an undistorted output. Depending on your system the midrange and tweeter output may be on the same output channels.

Step 7 Fine-tune the output level between midrange and tweeters. Refer to the Internal Crossover Configuration section of this manual for detailed instruc- tions.

Step 8 Repeat Steps 5-7 for the rear speakers. If you do not have rear speakers con- tinue to Step 10.

Step 9 Set levels between the front and rear midrange and tweeters for optimum front/rear balance.

Step 10 Turn up the level control corresponding to the woofer output until you hear slight distortion and turn back the level control slightly for an undistorted output.

Step 11 Fine-tune the output level between satellite speakers and the woofers. Refer to the Internal Crossover Configuration section of this manual for detailed instructions. If using an RGC-1, adjust the level to the output of the woofer to match the sonic requirements of the system.

Step 12 Enjoy your awesome Orion sound system.

16

©2003 Directed Electronics, Inc.

Image 17
Contents Page Contents What’s in the Box IntroductionPractice Safe Sound Record Your Serial Number and Date Limited TWO-YEAR Consumer WarrantyCrossover Section SpecificationsAmplifier Section Orion 600D Orion 1200D Orion 2500D END Panel Layouts Directed Electronics, Inc Amplifier Settings Adjusting INTELLi Q Fine Tuning the CrossoversLow-Pass Crossover High-Pass CrossoverEnclosure Type Boost Levels Infinite Baffle Example High-Pass Set at 30HzVented Example High-Pass Set at 30Hz Sealed Example High-Pass Set at 20HzSealed Example High-Pass Set at 30Hz Power Connections for the 600D and 1200D Amplifier WiringPower Connections for the 2500D Remote Gain OperationBridging Speaker ConnectionsGeneral Precautions and Installation Tips Amplifier InstallationChoosing Mounting Locations Passenger CompartmentTools of the Trade Step By Step InstallationTesting the System SET UP and TroubleshootingAdjusting the Sound of the System Symptom Probable Cause Action To Take Troubleshooting TipsInternal Crossover Configuration Directed Electronics, Inc Directed Electronics, Inc Warranty