Micro Innovations M000174-19 manual ActiveSync connection Windows CE, Activesync Connection

ActiveSync connection Windows CE

6ACTIVESYNC CONNECTION

An ActiveSync connection can be used for data transmissions, diagnostics or debugging. An exclusively DEBUG connection can also be created via «Manual Server» (see also Procedure: Manual Server). The ActiveSync connection requires the installation of the Microsoft ActiveSync program on the PC and the starting of the «Repllogswitch» program on the device. This connection can be implemented via the serial or USB interfaces. Depending on the MICRO PANEL, the installation of the «WceUsbSh.sys» driver is required on the PC for the USB connection. The driver files are contained in the GALILEO installation but are not automatically installed.

Note:

The connection requires at least ActiveSync Version 3.5. ActiveSync is a program from Microsoft and can be obtained free of charge from the Internet.

USB driver installation:

1.Connect devices with each other.

2.Select the .....WcUsbSh.inf file in the «New Hardware Found» dialog. The driver is located in the subdirectory «Tools\USB Driver» in the GALILEO installation directory.

6.1REPLLOGSWITCH

The «Repllogswitch.exe» program is used for establishing a connection with a PC via «ActiveSync» or «Manual Server». This is described in the chapter Procedure: ActiveSync or Procedure: Manual Server.

The program supports the call with the following command line parameters:

Parameter	Description
-s	The ActiveSync connection is started directly via the serial connection
	without the display of the above dialog.
-u	The ActiveSync connection is started directly via the USB connection
	without the display of the above dialog.
-e	The DEBUG connection is started directly via the Manual Server without
	the display of the above dialog. See also the chapter Procedure: Manual
	Server.
-a «IP address:port»	IP address and port number of the host PC for connection establishment
	using «Manual Server». This entry is absolutely necessary when using
	«Manual Server». See also the chapter Procedure: Manual Server.

Note:

The buttons «..USB..» and «..serial..» are only operable if the MICRO PANEL has the interface concerned and this is still available.

42 M000174-19