VocoPro HV-1200 owner manual Connecting Power, Connecting Speakers, Preparing the Speaker Cable

Getting Connected cont.

Connecting Power

What you will need:

•Surge Protector (recommended) or power outlet

•Included power cable

To connect Power to the HV-1200

1. Connect one end of the power cable to the rear panel of the HV-1200.

2.Connect the other end of the power cable to the power outlet or surge protector.

��������
�
�
���	���	���	���	������
				������

������������������

�������������

�������������

�������������

������������

���������������������

����������� ����������

��������������������

�������������������

����������������

Connecting Speakers

The Speaker Terminals are located on the rear panel. Be sure to connect the left channel (L), right channel (R), “+” (red) and “--” (black) properly.

•Before connecting the speakers, make sure that the HV-1200 is disconnected from the power source.

•Do not let the bare speaker wires touch each other or another metal part of this unit. This could damage the HV-1200 and/or the speakers.

Preparing the Speaker Cable

You can either use an exposed speaker wire or Banana Plug speaker cable.

Using Exposed Speaker Wire

1.Remove approximately 3/8” (10mm) of insulation.

2.Twist the exposed wires together to prevent short circuits.

3.Loosen the knob on the speaker terminal.

4.Insert the bare wire.

5.Tighten the knob until the wire is secure.

�	�	�	�	�
����

Using Banana Plugs	����������������
1. Plug the Banana Connector into the jack,
ensuring that the red and black connections
are aligned.

10