FUSE PROTECTION
A mains fuse is provided in the IEC power inlet on the back of this apparatus, which can only be removed with the power cord unplugged. This must be replaced by a fuse of the same type and rating (see Specifications or refer to rear panel)
IMPORTANT NOTICE FOR THE UNITED KINGDOM (Connecting the plug and cord)
The wires in the mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL
BROWN - LIVE
As the colours of the wires in the mains cable may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Make sure that neither wire is connected to the earth terminal of the three pin plug.
WARNING- STRONG MAGNETIC FIELD
Due to the powerful drive unit magnet, do not place within 1 metre (3 foot) of a cathode ray tube (CRT) television or monitor. There is no issue with plasma and LCD devices.
FCC INFORMATION (USA ONLY)
CAUTION: Any change or modification to this unit could void your authority to operate this equipment, granted by the FCC.
This apparatus has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to these instructions, may cause harmful interference to other electronic equipment. However, there is no guarantee that interference will not occur in all installations. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the distance between the equipment and the receiver.
•Connect the equipment to an outlet on a different circuit than the receiver.
•Consult your dealer or an experienced radio/ television technician for help.
This equipment has undergone safety and EMC testing, and complies with the European Low Voltage Directive 73/23/ EEC and Electromagnetic Compatibility Directives 89/336/EEC and 2004/108/EC.
SUB