DVD
VCD
CD
Switching Off
Power button
Press the power button ( 
).
When switching the power on (beginning play) again, tune the FM radio receiver to 88.9MHz or 88.3MHz (the frequency selected with the FM modulator frequency
select switch), and press the power button ( 
). Play will begin from the point where it previously stopped.
Note:
When listening in other mode of car stereo (radio mode, CD mode, etc.), switch the changer off. Leaving the changer on will produce noise heard on the radio, and reception will suffer.
■When the changer is connected directly to SANYO CD or
CD/Cassette Receiver with CD Changer Control model. zSee page 39, “Basic connection 2”.
Switch off the car stereo or switch the car stereo’s mode to other than changer (radio mode, CD mode, etc.).
To switch on the changer (begin play) again, follow the procedures below. Play will begin from the point where it previously stopped.
¡When the car stereo is off, switch on the car stereo (and press its changer mode select button if it is not in changer mode).
¡When you are listening in other mode of car stereo (radio mode, CD mode, etc.), press the changer mode select button of car stereo.
Notes:
¡The power button ( 
) of the remote control cannot be used. ¡Refer to the operation manual of car stereo.
Stopping Play
Play button
Pause button
Stop button
To Stop Play
Press the stop button ( 
).
Play stops (and the Resume Playback function becomes active).
Resume Playback Function
¡When the stop button ( 
) is pressed during play, the unit stores the position where play stopped. This is called the Resume Playback function. When this function is operative, the unit displays “Resume . . .” for a DVD or video CD. For an audio CD, the running time remains displayed when play is
stopped. When the play button ( 
) is pressed, play resumes from the point where it stopped.
¡The Resume Playback function is released in the following instances.
•The stop button ( 
) is pressed again.
•A magazine is ejected and then reinserted.
To resume play, press the play button ( 
).
If the Resume Playback function is operative, play resumes from the point where it stopped.
If the Resume Playback function is not operative, the disc plays from the beginning.
Pausing (Freezing)
Press the pause button ( 
).
With an audio CD, the audio stops and the running time display blinks. With a DVD or video CD, the video freezes (and the audio stops too).
Press the pause button ( 
) again to resume play from the point where it stopped.
*On some occasions, video and/or audio may stop for an instant right after restarting to play DVD or video CD. It is not the sign of unit trouble.
DVD
VCD
CD
B
A
S
I
C
O
P
E
R
A
T
I
O
N
10