Sanyo DV-S100 manual Message displays, Troubleshooting

Message displays

For easier understanding, the following messages are displayed during operation.

	Message	Cause	Remedy	Page
“	This disc	Attempting to play a DVD other	The region number of the unit is
can’t be		than one with a region number of	“2”. DVDs with a region number	6
played.”		“2” or “ALL”.	other than “2” or “ALL” cannot be
			played in the unit.
		The audiovisual restriction	Check the parental level settings
		function is operative and the unit	in the setup. Change the parental
		is prohibiting DVD play.	level in the unit to match the	31
			parental level of the DVD you are
			trying to play, and the disc can
			then be played.
“	You can’t	The command is not available for	A DVD can prohibit certain	–
operate this		the DVD in play.	operations as the disc maker
command			desires.
now.”		The command is not available on	When the screen advances, the
				–
		the screen displayed.	command will become functional.
“This disc can’t		Attempting to play a disc that the	Use a disc that the unit can play.	6
be played.”		unit cannot play.
		Disc loaded upside down.	Load disc properly.	3
		Dirty disc.	Clean disc.	3
		Moisture on the laser lens of unit.	Remove the magazine from the	–
			unit and wait about one hour.
“All discs can’t		All of the discs in the magazine	Use a disc that the unit can play.
be played.”		are discs that the unit cannot		6
		play.
“Magazine is		A magazine has not been	Insert a magazine in the unit.	3
not loaded.”		inserted in the unit.
“Magazine		There are no discs at all in the	Insert a disc in the magazine.	3
empty”		magazine.

Troubleshooting (1)

An error made during operation or installation can sometimes be mistaken for a system malfunction. Check below before contacting your Authorized SANYO Service Station.

Symptom	Cause	Remedy	Page
No power	Blown fuse	Replace with a properly-rated
		fuse. If the fuse blows again,	38
		consult with your dealer.
	Improper connection	Check connections.	38~40
Magazine	Direction in which it is inserted is	Insert it in proper direction.
cannot be	wrong.		3
installed.
Play does not	A disc is not inserted or is	Insert the disc properly, with the	3
begin.	inserted upside-down.	play side up.
	The disc is dirty.	Clean any debris from the disc.	3
	The car battery voltage is low.	Charge the battery. If the unit still
		does not function, consult your	–
		dealer.
	A disc that the unit cannot play is	Insert a disc that the unit can	6
	inserted.	play.
	A DVD of a region number that	The region number of the unit is
	the unit cannot play is inserted.	“2”. Use a DVD with a region	6
		number of “2” or “ALL”.
	The audiovisual restriction	Check the parental level settings
	function is operative and the unit	in the setup.	31
	is prohibiting DVD play.
	The disc recorded in PAL format	Change the position of the TV
	is insered when the TV signal	signal format switch depending
	format switch of the unit is set to	on the disc’s TV signal format.
	“NTSC” position.		6
	The disc recorded in NTSC
	format is inserted when the TV
	signal format switch of the unit is
	set to “PAL” position.
When a	The disc in play prohibits the	The operation cannot be
function button	operation.	performed with the disc or the
is pressed,		scene in play (also refer to the
only the “ ”		instructions included with the	–
is displayed,		disc).
and the unit
does not
function.
Image color or	Adjustment of brightness, tone,	Adjust the brightness, tone, or
tone is poor.	or color depth is poor.	color depth on the monitor	–
		connected to the unit.

43