Turning the TV on/standby
Standby mode
•Switching on from standby
From standby, press POWER on the remote control or press POWER on the TV.
•To standby mode
If the TV is switched on, you can switch it to standby by pressing POWER on the remote control or press POWER on the TV.
NOTE
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the AC outlet.
•Minor power is consumed when the unit is in standby mode.
•When AC cord is connected, the POWER indicator lights in orange.
After few seconds, the POWER indicator will change to red or green lights, and then the TV can be operated.
Menu operation
1Press MENU and the MENU screen displays.
2Press c/d to select the desired menu.
(CHANNEL, PICTURE, SOUND, TIME, LOCK, SETUP)
3Press a/b to select the desired menu item. Press ENTER to proceed if necessary.
4Press a/b or c/d to select the desired item or adjust the item to the desired level. Press ENTER if necessary.
CHANNEL menu
Initial auto installation
When the TV powers on for the first time after purchase, the initial auto installation wizard appears. Follow the menus and make the necessary settings one after another.
1Press POWER to turn on the TV.
2Press c/d to select “Home” or “Store”, and then press ENTER.
Home:
•“Standard” will be the default value for the “Picture Mode” setting.
Store:
•“Dynamic” will be the default value for the “Picture Mode” setting. If the “Picture Mode” is changed, the TV will automatically switch back to “Dynamic” when there is no further change to TV setting for 30 minutes.
•The confi rmation screen appears only when
selecting “Store”.
Press c/d to select “Yes” or “No”.
•To change the Store mode to Home mode, please refer to page 14 to reset the unit.
Press a/b to select your country channels listed on the screen, and then press ENTER.
•Auto installation will be executed.
•You do not need to do anything during the auto search.
•If you want to skip ATV or DTV tuning, press MENU to exit. Press c/dto select “Yes” or “No”.
NOTE
•You can set initial auto installation manually in the “First Time Installation” on the “SETUP” menu screen. (See page 14.)
| Auto Tuning |
|
| ATV Manual Tuning |
|
| DTV Manual Tuning |
|
CHANNEL | Programme Edit |
|
Signal Information |
| |
| Software Update(OAD) | On |
H Auto Tuning
You can run auto tuning again, even after setting up the preset channels.
1Press MENU and the MENU screen displays.
2Press c/d to select “ 
” (CHANNEL).
3Press a/b to select “Auto Tuning”, and then press ENTER.
4If you have already set the password, enter it here.
• See page 11 for setting a password.
5Press c/d to select “ATV+DTV”, “DTV” or “ATV”, and then press ENTER.
You do not need to do anything during the auto search. Press MENU to exit.
•If you want to skip ATV or DTV tuning, press MENU to exit. Press c/dto select “Yes” or “No”.
8