Jensen MS4200RS Connection overview, ISO connector A, Fig, Telephone mute function A3, optional

Page 7

INSTALLATION INSTRUCTIONS

Connection overview, ISO connector A, Fig. 2:

Pin

Wire color

Connection

A1

Orange

Input speedometer signal / SDVC

A2

Green

Switch input reversing signal (reversing light plus)

A3

Purple

Switch input telephone mute function

A4

Red/Yellow

+ 12 V permanent positive; terminal 30

A5

Blue

Switch output for automatic antenna / relay motor antenna

A6

Grey

Switch input pilot light

A7

Red

+12 V ignition positive; terminal 15 (without switch-off on starting engine)

A8

Brown

Battery negative; terminal 31

AOnly connect electrical signals to suitable connecting points in the vehicle.

AIf connection is made directly to the battery, protect the positive lead (red lead) with a 10 A fuse close to the battery (max. distance 4 to 6 inches).

■Speedometer signal (A1):

Connect orange lead A1 to the vehicle speedometer signal. Refer to the vehicle-specific data sheets for location and connection details (available on CD-ROM).

Note: Many vehicles are equipped with a speedometer signal on one of the radio connectors. For further information contact your vehicle dealer or our hotline.

ADo not connect the speedometer signal to the ABS control!

■Reverse signal (Back-up lights) (A2):

Connect green lead A2 to a suitable point of the reverse signal lead (positive lead of reverse lamp circuit).

■Telephone mute function (A3), optional:

Connect purple lead A3 to the mute function output of the car phone or the hands- free unit. When the telephone is in use, the radio is muted or the telephone conversation is amplified via the car loudspeakers. See also “Green connector C2" on the following page.

■12 volt battery (A4):

Connect yellow/red lead A4 to a suitable connection with permanent voltage.

AThis connection should be rated for a current of at least 10 A.

■Electronic antenna or motorized antenna (A5), optional:

Connect blue lead A5 to the supply lead of an electronic antenna or to the control lead of a motorized antenna.

ADo not use this connection to supply the antenna motor. (i.e. high current)

■Illumination (A6), optional:

Connect gray cable A6 to the illumination circuit (positive lead). When

the parking lights are switched on, the ring around the VOL/POWER button lights up, even if the radio is switched off.

■12 volt ignition (A7):

Connect red lead A7 to a suitable 12 V circuit switched through the ignition.

4

Page 6 Page 8
Image 7
Page 6 Page 8
Contents MS4200RS Table of Contents IQ Intelligent Content on Demand Important notes for safe usage Class 1 laser productObey all traffic signs and laws while driving Safety and Warnings Taking safety precautions, Fig Connection in vehicles without standard ISO connectorsMaking the electrical connections Volt ignition A7 Connection overview, ISO connector A, FigVolt battery A4 Telephone mute function A3, optionalBlue connector C3 CD changer Connection overview ISO connector B loudspeakers, FigConnection overview ISO connector C Yellow connector C1 Preamp line-outInstall installation bracket Installing the GPS antenna, FigMounting the radio, Fig Checking the vehicle functions Initial operation, FigTechnical Support Important notes on the function of your navigation radio Start-up characteristicsRoute & Sound Navigating and listening to an audio CD How does the navigation system work?Topicality of the map CD Digital road mapComments Areas with limited road informationRemoving the operating panel Removable operating panelSecurity code Anti-theft protection LEDHandling CDs RDS Radio Data SystemTEL Control elementsNavigation mode Radio modeCD player mode CD changer modeRemoving a CD Switching on / offVolume Inserting a CDCursor Menu operationReturn Active option Option Inactive optionCityW ‰ ¡ Z ¯ Entering lettersNormal and expert modes Choosing the user modeActivating functions in common mode Activating functions in expert modeTMC Scan Information menuTA Scan News Ann. level Displayed message … Behavior of TMC and TATraffic announcements from other stations EON Sound menu Sound SettingsPage Radio Setting stationsRDS Memo Autostore Store Preset Recall ProgramRadio menu RadioInitialization Radio SetupExtra info PTY search only on FMCD Player Rnd CD playerCD playback Selecting a functionScan CD menuRepeat Track CD Title Extra Info Selecting a CD CD changer accessoriesCD changer playback 1044Random CD Changer SetupCD Changer menu Random Repeat Track Select CDScan Time 15s On Off Logic Clock SettingsInitialization menu Beep LevelIcons On Off LogicDisplay UserNavi ID Navi ID 8Q6S 7ED4 CD EUR 2003/01 NT SW ID IQ Your key to map, traffic and travel informationActivation options Registering the navigation systemR 5 Z 4 a K Activating productsMy C-IQ Code InputIQ Info IQ SettingsIQ Service PreviewMain menu Load address Last destin. Info on car pos Destination inputDestination input menu Destination input New addressCountry Entering a new addressCityW I.....ODirectly to guidance Step RoadStep House number or intersection Step Route selectionSpecial facilities of national importance Points of interest POIsSpecial facilities in connection with the destination Destination input via GPS coordinates Special facilities in the vicinity of the current position26 km Via point input New address Via point inputDelete via points not reached Guidance MlsRepeating voice message Turn now adviceAudible messages Improved acoustic guidance information15 mls UI 1127am Guidance beyond digitized roadsAreas with limited road information 4,1mls UI 0245pmRoute selection B49 Mls Information during guidanceAb Anschl Mls A45 18.8 GPS / Compass 04/02/03 812 am Trip computer 35 mph 24 mph Mph 235 mlsDisplaying / deleting via points DestinationYes Cancel procedureAlternative route Alternative routeDelete via points Address managerStoring addresses in the address book Delete addressDeleting list of last destinations Store current locRenaming addresses Car position Emergency menuEmergency GPS positionSpeed System settingsGuidance screen Dyn. route sett. Language Language Settings for dynamic route planningGuidance screen Dyn. route settSystem Info Default settingsService Mounting angleLoading software updates Symptoms Possible cause / remedy TroubleshootingNavigation Month Limited Warranty CEA Power Ratings SpecificationsPage 033104

MS4200RS specifications

The Jensen MS4200RS is a highly regarded marine audio system designed for boating enthusiasts who prioritize high-quality sound and durability in a marine environment. This versatile unit combines the latest technological advancements with rugged features tailored for marine applications, making it a top choice for boaters.

One of the standout features of the Jensen MS4200RS is its extensive compatibility with multiple audio sources. It integrates seamlessly with Bluetooth, allowing users to connect smartphones or other devices wirelessly to stream music effortlessly. Additionally, it has built-in support for AM/FM radio, providing access to a wide array of radio stations for on-the-water entertainment.

The unit's user-friendly interface is another commendable aspect of the Jensen MS4200RS. It is equipped with a large, backlit LCD display, ensuring visibility even in bright sunlight. The intuitive controls allow for easy navigation through playlists, radio stations, and settings, facilitating a hassle-free user experience while cruising.

One of the critical considerations for marine audio systems is durability. The Jensen MS4200RS boasts a marine-grade design, complete with a weather-resistant rating. This resilience against splashes and humidity means that boaters can enjoy their favorite tunes without worrying about damage from the marine environment. The unit is built to endure the rigors of outdoor use, making it an ideal companion for any sea voyage.

Sound quality is paramount in any audio system, and the Jensen MS4200RS delivers impressive audio performance. It features a built-in amplifier that provides ample power to drive speakers, resulting in clear and powerful sound across a wide frequency range. Additionally, the unit includes customizable equalizer settings, allowing users to tailor the audio output to suit their preferences or the acoustics of their boat.

Moreover, the MS4200RS is designed with expandability in mind. It supports multiple audio outputs, enabling users to connect additional speakers or subwoofers, thereby enhancing the overall audio experience. The versatility of the system caters to the needs of both casual listeners and audiophiles alike.

In summary, the Jensen MS4200RS represents an excellent choice for marine audio enthusiasts. With its robust features, advanced connectivity options, user-friendly controls, and durability, it stands out as a reliable companion for music lovers on the water. Whether for a leisurely day on the lake or a more adventurous sea journey, the Jensen MS4200RS promises quality sound and performance in a marine-friendly package.
Top Page Image Contents