LEARNING CODES FROM A REMOTE CONTROL
•Remember to press the appropriate Input Selector 0 button before functions are changed to another device.
3.When all the steps have been entered, press the M N KL 9 button to enter the commands. The red light under the Input Selector 0 will blink and then turn off and the Program
Indicator will flash green twice, to confirm the macro to be programmed.
Example: To program the Macro 1 K button so that it turns on the CS3/CS5 and your TV, follow these steps:
•Press the Macro 1 K and Mute A buttons at the same time and then release them.
• Note that the Program Indicator | will flash amber. |
•Press the TV Selector 0.
•Press the Mute A button to store the CS’s power on command.
• Press the Screen Power On | button to store the TV Power On |
Command. |
|
•Press the M N KL Channel Up 9 button to complete the process and store the macro sequence.
After following these steps, each time you press the Macro 1 K button, the remote will send all Power On commands.
Erasing Macro Commands
To remove the commands that have been programmed into one of the Macro buttons, follow these steps:
1.Press the Mute Button A and the Macro Button K that contains the commands you wish to erase.
2. Note that the Program Indicator will flash amber, and the red LED under the Input Selector 0 last used will turn on.
3.Within ten seconds, press the Mute Button A.
4.The red LED under the Selector will go out, and the Program
Indicator will turn green and flash three times before it goes out.
5. When the Program Indicator | goes out, the Macro has been |
erased. |
|
30