Jensen 1050, 900, 880 Testing, Remote Input Level Control, Reconnect Battery, Test Power Wiring

Page 13

Testing

Before finishing the installation, perform the following tests to make sure the wiring is correct and everything is operating properly.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

Test Power Wiring

Turn on the receiver, but do not turn up the volume. The amplifier power light should come on. If not, check the REM and +12V (B+) wires. Turn up the receiver volume slightly. All speakers should operate. If not, check wiring connections at amplifier and speakers.

Test Speaker Connections

These tests make sure the speakers are connected properly. If speakers don’t play at all, one (or both) speaker wires may be disconnected.

POWER Amplifiers

Remote Input Level Control

The Power 900 and 1050 come equipped with a Remote Input Level Control. The Remote Input Level Control allows the input level to be adjusted from an alternate location. It can be mounted under-dash or in-dash. When the amplifier is used to drive subwoofers and the low pass crossover is activated, the Remote Input Level Control can be used as a “remote bass level control”. This enables you to control the bass level independent from the rest of the system. This is convenient for system tuning and/or when playing many different types of music.

The Remote Input Level Control uses a 6-pin modular cable for connectivity. Simply plug the 6-pin modular cable into the amplifier and then into the Remote Input Level Control to activate the circuit.

Power

Min Max

REMOTE

CONTROL

 

 

 

 

 

OUTPUT

INPUT

POWER

BASS

SUB

LOW

 

L

L

 

BOOST

SONIC

PASS

LEVEL

 

 

 

PROTECT

REMOTE

 

 

 

 

R

R

CONTROL

0dB 12dB

10Hz 40Hz

40Hz 300Hz

4V 0.4V

 

 

 

 

 

 

11

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Power Amplifiers PowerPlus Amplifiers Introduction Warranty ServiceBefore You Begin Specifications Features and SpecificationsPower Output Installation Assistance Supplies and Tools Needed InstallationDisconnect Battery Routing WiresPower Terminal +12V/B+ Power WiringCharging System Remote Terminal REMGround Terminal GND Replacement Fuse Requirements FusePower 400/880 Speaker WiringPower 900/1050 Two SpeakersFour Speakers Power 760/920Two Speakers and Bridged Subwoofer Two SubwoofersChannel Input WiringConnecting Additional Amplifiers Indicators and Controls Reconnect Battery TestingTest Power Wiring Remote Input Level ControlProblem Possible Cause Corrective Action TroubleshootingRMS Power Output @ 1% THD+N, 14.4VDC CEA Power OutputPower Amplifiers Antes de Empezar IntroducciónServicio de Garantía Especificaciones Características y EspecificacionesSalida de Potencia Desconecte la Batería InstalaciónUbicación y Montaje CableadoSistema de Carga Cableado de EnergíaTerminal de Potencia +12V/B+ Terminal Remota REMRequerimiento de Fusible de Reemplazo Fuse Terminal a Tierra GNDAltavoz Dos Altavoz Uno Cableado del AltavozTri-Modo Dos Altavoces y Altavoz de Graves en Puente Cuatro AltavocesDos Altavoces de Graves Cableado de Entrada Conectando Amplificadores Adicionales Indicadores y Controles Control de Nivel de Entrada Remoto TesteoReconecte la Batería Verifique el Cableado de EnergíaProblema Causa Acción Correctiva Localización de ProblemasSalida de Potencia RMS @ 1% THD+N, 14.4VDC Salida de Energía CEAAmplificadores Power Avant de commencer Service de garantiePower 900/1050 Power 400/760/880/920Fonctions et spécifications SpécificationsEmplacement et montage Aide dinstallation Outils et fournitures requisDébranchez la pile Routes des câblesSystème de charge Câblage puissantBorne de puissance +12V/B+ Borne à distance REMBorne à terre GND Exigences de fusible de remplacements FusibleDeux haut parleurs Câblage des haut parleursDeux haut parleurs et un caisson de basse ponté Quatre haut parleursDeux caissons de basse Câblage dentrée Branchements des amplificateurs supplémentaires Indicateurs et Contrôles Contrôle du niveau dentrée à distance EssaisRebranchez la pile Essayez le câblage de puissanceProblèmes Cause Rectifications DépannageSortie de puissance RMS @ 1% THD+N, 14.4VDC Sortie de puissance CEAMonth Limited Warranty Radios del CD o de los Multimedia Garantía LimitadaGarantie Limitée Page Audiovox Electronics Corporation Hauppauge, NY

400, 920, 760, 880, 1050 specifications

The Jensen 1050, 880, 760, 920, and 400 are models of high-performance vehicles known for their blend of luxury, performance, and advanced technology. Each model showcases Jensen's commitment to engineering excellence and design innovation.

Starting with the Jensen 1050, this model is often recognized for its powerful engine options, including turbocharged variants that enhance performance while maintaining efficiency. The 1050 features an elegant exterior design characterized by sleek lines and an aerodynamic profile. Inside, it boasts premium materials and cutting-edge infotainment systems, providing a luxurious driving experience with the latest connectivity options.

Moving to the Jensen 880, this model emphasizes comfort and technology. Equipped with enhanced safety features, advanced driver-assistance systems, and spacious interiors, it is ideal for families or those seeking a comfortable ride. The 880 is powered by a robust yet efficient engine, ensuring a smooth and responsive driving experience. The incorporation of noise-canceling technology further enhances the serene ambiance inside the cabin.

The Jensen 760, on the other hand, is designed for performance enthusiasts. With a focus on agility and handling, it comes with sport-tuned suspension and precision steering. The 760's engine is responsive, delivering thrilling acceleration and power. Additionally, it features advanced brake systems that provide confidence-inspiring control in various driving conditions. The sporty interior layout is complemented by driver-centric technology displays that offer real-time performance analytics.

The Jensen 920 is known for its versatility. This model seamlessly combines luxury with practicality, featuring configurable interior spaces and robust storage options. Its hybrid engine technology stands out, making it an eco-friendly choice without sacrificing performance. The 920 is equipped with state-of-the-art infotainment systems, including AI-driven interfaces that learn driver preferences.

Lastly, the Jensen 400 serves as an entry-level model with a comprehensive range of features. Despite its more affordable price point, it does not compromise on quality or technology. The 400 includes efficient engine options, modern safety features, and an intuitive control system. It is designed for everyday use while offering a comfortable and enjoyable driving experience.

Together, these Jensen models showcase a commitment to quality, performance, and innovation in the automotive industry, appealing to a wide range of drivers with varying needs and desires.
Top Page Image Contents