Marantz SA-14S1 owner manual NnComputer recommended system, NnPlayback

Page 25

NOTE

•The dedicated driver must be installed in the computer before this unit is connected to a computer. Operation will not occur correctly if connected to the computer before the dedicated driver has been installed. Moreover, if the

computer is running Windows XP as its OS, the computer’s speed will decrease significantly, and a computer restart may be required.

•Operation may fail in some computer hardware and software configurations.

nnComputer (recommended system)

OS

•Windows® XP Service Pack3, Windows® Vista, Windows 7 or Windows 8

•Mac OS X 10.6.4 or later.

USB

• USB 2.0: USB High speed/USB Audio Class Ver.2.0

NOTE

If the computer you use is “Mac OS“, please check if the “USB High Speed Audio“ format is set below “192000.0 Hz“ using the “Audio MIDI Setup“.

nnPlayback

Install the desired player software on your computer beforehand.

Use the rear panel USB port to connect this unit to a personal computer. For the connection procedure, refer to the “Connecting a PC or Mac” (vpage 11) section.

1 Press DISC/INPUT to change the input source to “USB- DAC” (vpage 13).

Start playback on the computer’s player software.

2 The input digital audio signal is displayed as shown.

“USB: zzzzk”. or “USB:DSD zzzM”

(zzzz indicates the sampling frequency. )

•If the sampling frequency cannot be detected, “Signal Unlock” will be displayed.

•When “USB: XXXXX” is displayed on this unit, wait for approximately 10 seconds, and then start and operate the music playback software on the computer. This unit functions as a D/A converter.

ENGLISH

Using as a D/A converter

NOTE

•Perform operations such as playback and pause on the computer. At this time, you cannot perform operations with buttons on this unit or the remote control.

•You can also control the volume and equalizer on the computer. Enjoy playing music at the desired volume.

•When this unit is functioning as a D/A converter, sound is not output from the computer’s speakers.

•If the computer is disconnected from this unit while the computer music playback software is running, the playback software may freeze. Always exit the playback software before disconnecting the computer.

•When an abnormality occurs on the computer, disconnect the USB cable and restart the computer.

•The sampling frequency of the music playback software and sampling frequency displayed on this unit may differ.

•Use a cable that is 10 ft/3 m or less to connect to the computer.

Preparation

Connections

Playback

nnFiles that can be played back

• See “D/A converter” (vpage 31).

Settings

Tips

Appendix

22

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Super Audio CD Player Important Safety Instructions Avertissements Advertencias Preparation ContentsAbout the remote control AccessoriesOperating range of the remote control Inserting the batteriesToroidal transformer FeaturesLarge-capacitance block capacitor Front panel Part names and functionsRear panel NnButtons for Super Audio CD player Remote controlNnButtons for amplifier Connections Connecting to a stereo audio amplifierCables used for connections Audio cableConnecting to a device with digital audio output connectors Connecting to a device with digital audio input connectorsCD transport/ Devices with digital audio connectors AV receivers ConvertersNnSupported iPod/iPhone models Connecting an iPod or USB memory device to the USB portIPod Memory DeviceRemote control connection Connecting a PC or MacNnSetting NnConnectionConnecting the power cord Connecting the timer deviceTimer device This unit AmplifierSwitching the input source Turning the power onPlayback Basic operationPlaying Super Audio CDs or CDs Playing CDsHaving the display and the illumination lamp off Switching the displayRepeat playback Playing tracks in a specific order Program playback Random playbackStopping digital outputs Playing files Playing Data CDsPlayback iPod Disconnecting the iPodPlaying an iPod Removing the USB memory device Playing a USB memory deviceConnecting and playing back from a computer USB-DAC Using as a D/A converterInstall the driver Disconnect the USB cable between your computer and the unitChecking audio output Press X on this unitNnPlayback NnComputer recommended systemPress Filter Switching the filter characteristicsOr Optical vpage Filter Audio CD Super Audio CD TypeTimer Play SettingsNnUsing the timer play function Menu mapDisp Info Play FileIPod Ctrl USB ResumeTips Tips TroubleshootingSymptom Cause NnPower does not turn on / Power is turned offSymptom NnDisplay on this unit shows nothingNniPod cannot be played back NnCDs cannot be played backNnSound is interrupted or noise occurs NnPC or Mac files cannot be played back NnUSB memory devices cannot be played backPlayable media AppendixDiscs USB memory devicePlayback order of files Data CD / USB memory device ConverterAbout Folders and Files Inserting a disc How to handle mediaExplanation of terms Cleaning discsIndex SpecificationsNn Audio performance Weight / Poids / Peso / 31 lbs 15 oz 14.5 kg Dimensions / Dimensions / DimensionsUnit / Unité / Unidad / inch / pouces / pulgadas mm
Top Page Image Contents