Maxxsonics GPV3000.1D PRO GPV2000.1 A/B Class 1 Channel Amplifier Application, Basic application

GPV2000.1 A/B CLASS 1 CHANNEL AMPLIFIER APPLICATION

Basic application

These sub bass amplifiers can be used in any of the bi-amplification systems described in this manual, replacing the 2 channel amplifiers as per the illustrations.

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Connect the LINE OUT to the inputs of the system highs amplifier.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals, simplifying the hookup of multiple speakers

Crossover frequency control checklist:

LOW PASS: 35Hz to 250Hz

SUBSONIC:15 Hz to 35 Hz

BASS EQ: 0 to +9dB

PHASE: 0 to 180 degrees

Level control checklist:

Refer to the section “Setting up systems after installation for best performance”

Minimum final loudspeaker impedance: 1-Ohm.

MIN MAXX

GPR-1

DESIGNATED

MONO OUTPUT FROM HEAD UNIT

NO FLASH	FLASH
	PROTECT	POWER
REMOTE
0dB 9dB	BOOST	BASS
15Hz 55Hz	SONIC	SUB
40Hz 150Hz	PASS	LOW
6V 0.	LEVEL
2V
R	L	OUTPUT
		INPUT
R	L

30th ANNIVERSARY

GROUND POUNDER

	-		MONO
SPEAKER	- +
			SUBWOOFER
	+
	FUSE
	+12V	TO BATTERY + 12 Volts VIA FUSE
		REMOTE TURN-ON
POWER	GND REM
		CHASSIS GROUND

PARALLEL MONO

SUBWOOFERS

2-OHMS EACH MINIMUM

	-
EAKER	-
S
	+
	FUSE
	+12V
POWER	REM
	GND

FULL RANGE
STEREO LINE INPUT	Y-ADAPTOR

NOT USED

Note: You can use the Radio/CD designated mono line output or a full range stereo line output. For full range stereo line output, you will need an optional “Y-Adaptor” as shown.

7