Solutions to Common Problems
1.To adjust individual colors, press and hold briefly, and then release the EQ/Skew knob until the desired color LED is flashing for the R/G/B LED. The LED color corresponds to the color channel being adjusted.
2.Using the image utility, turn knob to add/subtract delay timing until a single vertically aligned line of red, green, blue is obtained.
3.When complete, press and hold briefly, and then release the EQ/Skew knob until the R/G/B LED is solid green.
Not all colors will have the same delay settings.
5 Solutions to Common Problems
In most cases, nearly every issue with the Cobra series can be resolved by checking the CAT 5 termination and making sure that it’s pinned to the TIA/EIA 568B wiring specification. However, there may be other problems that cause the system to not perform as it is designed. Below are solutions to the most common installation errors.
Problem: | No video signal at the transmitter local port or at the receiver. |
Solution: | Check that both units are powered. |
| Ensure EQ adjustment is set correctly — turn knob slowly. • Make |
| sure the CAT 5 cable is terminated correctly per the TIA/EIA |
| 568B wiring specification. |
| Is the display device powered on and functioning? |
| Check to ensure display settings (resolution, refresh rate, etc) are |
| compatible with input signal. |
Problem: | Poor video quality. |
Solution: | Have all receiver adjustments been finished? |
| Ensure EQ adjustment switches are set correctly |
| Check all cable connections |
| The video signal’s refresh rate may be set too high. Reset to a |
| lower refresh rate in your |
| There may be a delay skew issue. See Section on Skew |
Problem: | Poor audio quality. |
Solution: | Powered speakers are required. Make sure speaker power is ON |
| Check input source levels from the source device. Make sure the |
| audio source is not overdriven or underdriven. |
| Audio is summed left and right for “A” versions. If using a single |
| channel, both audio inputs must be connected at the transmitter |
| end for full audio gain. Audio is line level |
| Serial//audio units support full stereo line level. |
8 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |