Kramer Electronics Cobra R1300A Connections on the Single-Port VGA/Audio, Transmitter Connections

Page 7

Setup and Installation

With regard to connecting the cables:

￿We recommend mounting and connecting all cabling to the Cobra R1300A / R1300S2 components before applying power.

￿Be sure that the CAT 5 cable you intend to use has been tested to comply with the T568B wiring specification (see Appendix A).

4.3Connections on the Single-Port VGA/Audio

The single-port units with audio support video and audio signals over CAT 5 cable. The audio signal is line-level summed Right/Left audio, and powered speakers are required. You can also use the transmitters and receivers to make video-only connections without audio. Figure 1 shows the Single-Port Cobra CAT 5 Video System with Audio Transmitter connections, and Figure 2 shows the receiver connections.

Figure 1: Transmitter Connections

Figure 2: Cobra R1300A Video / Audio Receiver Connections

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Models Tables ContentsIntroduction Overview Getting StartedOverview Data Mode Configuration Setup and InstallationMaking the Connections Transmitter Connections Connections on the Single-Port VGA/AudioCobra R1300S2 Universal Receiver Connections Connections on the single-port VGA S2Adjustment locations Video AdjustmentSolution Solutions to Common ProblemsProblem Solution Terminal Block Connection Appendix a Cabling PinoutsDB9 Video Connector Pinout Appendix B Configuration Settings Configuration Jumper Settings Appendix D Setting Sync Mode Skew Module Appendix E Skew ModuleVideo Support Technical SpecificationsPage 2900-650004 REV
Top Page Image Contents