7
Mounting
BombA 27 V1 User Manual
A power supply kit dedicated to the BombA cabling will shortly be available at your supply.
•Unplug the «+» from the battery
•Make sure you follow the car manufacturer instructions (airbag, alarm system, computer, immobiliser ...).
•Always use battery lead connections.
Cable routing
The 12V supply cables should be passed down one side of the vehicle and the signal cables down the other. These cables must be suitably protected to avoid any damage to the insulation, especially when feeding the cable through from the engine compartment to the passenger cabin.
Power supply
(+)The 12V cable must be connected to the battery with a cable of appropriate quality and size, 8mm2 (7AWG) . Protect the installation with a 30A fuse on this cable fitted less than 40cm (16”) away from the battery.
Connect the remote cable to the electrical aerial output or to the remote output of your radio.
Low level input (RCA)
Connect to the RCA output of the radio
Connect to the loudspeaker outputs of the radio.
Never connect the RCA and the
Adjusting the Volume
The volume setting allows you to match the level of the BombA with the level of the front system. Setting: - Turn the gain on the BombA down completely
-Turn the radio up to a normal listening level.
-Turn the gain up on the BombA until you get the required balance.
3 settings:
-Techno
-Pop
Note that these settings should be used together with the level adjustment.