Baldor MN850 Appendix B Parameter Values, Title Parameter Adjustable Range Factory User Setting

Appendix B Parameter Values

Version 5MC (4/2/01)

Read Only Parameter Values

Title	P#	Parameter	Adjustable Range		Factory	User Setting
Parameter	P0	Dummy Parameter	0–255	0
	P1	Station Number	1–99	1
	P2	Country	1–255	44 (England)
	P3	Software Type	Factory Set	Read Only
	P4	Software Version	Factory Set	Read Only
Password	P5	Password Value	0–255	0
Advanced	P6	Firing Mode	0–3	0
Basic	P7	Protection Mode	0–192	192 (Full + Optimize)
Parameters	P8	Status 1	0–255	1	(bit 00000001)
	P9	Status 2	0–99	0	(bit 00000000)
	P10	Status 3	0–255	0	(bit 0000000)
Basic	P11	Start Pedestal	10–60%	20 (% of line volts)
	P12	Start Time	1–255 seconds	5	(seconds)
Advanced	P13	Kick Pedestal	60–90%	75 (% of Line)
	P14	Kick Time	10–40 cycles	25 Cycles
	P15	Dwell Time	1–255 seconds	5 seconds
Basic	P16	Stop Pedestal	10–60%	10 (% of Line)
	P17	Stop Time	0–255 seconds	0 seconds
Auto Features	P18	Auto Config.	0–255	6	(bit 00000110)
Advanced	P19	Optimise Rate	4–30	5	(for unstable load)
Parameters	P20	Reference PF (Power Factor)	0–147 degrees	146.7626 degrees
	P21	Present PF (Power Factor)	0–147 degrees	146.7626 degrees
	P22	Delay Angle (SCR OFF time)	0–147 degrees	146.7626 degrees
	P23	Maximum Optimizing Delay	17–147 degrees	57.55396 degrees
	P24	Rated Current (High Byte –Hundreds)	Factory Set	Factory Set
	P25	Rated Current (Low Byte – Units)	Factory Set	Factory Set
	P26	Running Current Amps	0–255 Amps	0	Amps
	P27	Peak Start Current (measured at last start)	0–255 Amps	0	Amps
Advanced Current	P28	Low Current Level (undercurrent trip)	100–800% of running	9.375% of running
			Amps (P24 & P25)	Amps
	P29	Low Current Time (delay before trip)	5–255 seconds	50 seconds
	P30	Current Limit Level (scaling = 0.03125)	1–7.96875 (x Ie) Amps	350% of running
				Amps
	P31	Current Limit Time (delay before trip)	5–255 seconds	30 seconds
	P32	Shearpin Level (undercurrent trip)	1–5 (x Ie) Amps	3.125 x Ie Amps
	P33	Shearpin Time (delay before trip)	5–255 cycles	100 cycles
	P34	Overload Level (SCR protection)	0.59–2 (x Ie) Amps	1.09375 x Ie Amps
	P35	Overload Delay (delay before trip)	10–140	140

Note: (x Ie) means “Times the rated current of the control (P24 and P25 values).”

MN850 Applications B-1