DSR 9401 FTA / DSB
OPERATING THE RECEIVER | OPERATING THE RECEIVER |
DSR 9401 FTA / DSB
-9401F / DSB-9401V
1.1 LNB Setting
You can select the satellite and LNB setting conditions to execute channel search and you can alter the settings for 22KHz tone. The parameters set in this menu are needed for programming the channels for the "Auto scanning" and "Manual scanning".
The necessary information can be found at your antenna and LNB brochures, or you can ask your dealer.
●Select LNB power supply "On".
●Select the desired satellite name.
●Select the LNB type (frequency).
●Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)
If you are using a Positioner, select this option. (“Yes” or “No”)
22KHz: In case you are using a dual LNB or two antennas connected to a 22 kHz tone switch box, with the 22 kHz tone switch ("On", "Off" or "Auto") you can switch between both LNB or antennas.
1.2 Positioner Setting
If you have a DiSEqC 1.2 motorized system, then you can take advantage of the DiSEqC 1.2 functions available.
●Select Satellite.
●Select any transponder from above satellites and check out the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
●Select from Menu Mode:
"User" mode : Enables control of basic positioner function recommended for beginners. General user uses “User” mode.
"Installer" mode : Complete control of the positioner’s full functions recommended for installers and professional users.
1.2.1User Mode
●Select Driving Mode:
You have an option to choose the positioner’s movement type: Continuous, Step or Time.
●Position the antenna with north, south, east
and west and use the 
/ 
,
/ 
key to drive motor. 
key drives to west, 
key drives to east, 
key drives to north and 
key drives to south.
●If you finished driving of motor, select “Store current Position.” and press 
key, to reset new driving motor.
Nottee : The level indicated in the “Signal Status” is only for reference.
The signal quality may be adequate even though the level indicated is not maximum.
●Go to Stored Position.
When the stored position is reached then screen displays "Stop", you can now continue with the further operations.
●Select the Calculate Sat Positions to recalculate the satellite position and 
key.
-9401F / DSB-9401V
GB
D I G I T A L | S A T E L L I T E | R E C E I V E R |