Installation, Connection to your Personal Computer

Installation

E - 8

Installation

Connection to your Personal Computer

The MultiSync LCD1810X true colour monitor complements PC compatible computers. Your system has one of two configurations:

–the video controller is built into the computer.

–the video controller is in the form of a display card (sometimes referred to as graphics card, video adapter or graphics board).

Both configurations have a video connector (or a CRT PORT on laptop computers). If you are not sure which connector is the video connector, refer to your computer or display card manual.

To attach the MultiSync LCD1810X monitor to your system, follow these instructions:

1.Turn off the power of your computer.

2.For the PC with DVI digital output: Connect the DVI-D to DVI-D signal cable to the connector of the display card in your system (Figure A.1). Tighten all screws.

For the PC with DFP digital output: Connect DVI to DFP Adapter to the computer (Figure A.2).

Attach DVI-D to DVI-D cable to the DVI to DFP Adapter. Tighten all screws.

For the PC with Analog output: Connect the 15-pin mini D- SUB to DVI signal cable to the connector of the display card in your system (Figure A.3).

To connect a secondary PC with analog output, connect the 15-pin mini D-SUB to 15-pin mini D-SUB signal cable (not include) to the connector of the display card in your system.

For the Mac: Connect the MultiSync Macintosh cable adapter to the computer (Figure B.1). Attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).

English

Deutsch

Français

Español

Italiano

Appendix

CN912B-2/LCD1810X/78135322

00.5.26, 0:03 PM