EM_550_G2.book Seite 63 Donnerstag, 27. November 2003 1:33 13
Troubleshooting
Error checklist
Problem | Possible cause | Possible solution | |
|
|
| |
No operation indication | No mains connection | Check the connections of the mains | |
|
| cable | |
|
|
| |
No RF signal | Transmitter and receiver are not on | Set transmitter and receiver to the | |
| the same channel | same channel | |
|
|
| |
| Transmitter is out of range | Check the squelch threshold setting | |
|
| (see “Adjusting the squelch | |
|
| threshold” on page 58) or | |
|
| reduce the distance between | |
|
| transmitter and receiving antenna | |
|
|
| |
RF signal available, | Transmitter is muted (“MUTE”) | Deactivate the muting function | |
no audio signal, |
| (see operating manual of the | |
“MUTE” display appears on the |
| transmitter) | |
display panel |
|
| |
Receiver’s squelch threshold is | See “Adjusting the squelch | ||
| |||
| adjusted too high | threshold” on page 58 | |
|
|
| |
| Transmitter doesn’t transmit a | Switch the pilot tone transmission | |
| pilot tone | on the transmitter on or | |
|
| switch the pilot tone evaluation on | |
|
| the receiver off | |
|
|
| |
| Transmitter sensitivity is adjusted | Adjust the transmitter sensitivity | |
| too low | correctly | |
|
|
| |
Audio signal has a high level of | Receiver’s AF output level is | See “Adjusting the audio output | |
background noise | adjusted too low | level” on page 58 | |
|
|
| |
| Transmitter sensitivity is adjusted | Adjust the transmitter sensitivity | |
| too high | correctly | |
|
|
| |
Audio signal is distorted | Receiver’s AF output level is | See “Adjusting the audio output | |
| adjusted too high | level” on page 58 | |
|
|
| |
No access to a certain channel | During scanning, an RF signal has | See “Scanning the channel banks for | |
| been detected on this channel and | free channels” on page 57 | |
| the channel has been locked |
| |
|
|
| |
| During scanning, a transmitter of | See | |
| your system operating on this | page 58 | |
| channel has not been switched off |
| |
|
|
| |
During the soundcheck, only one | One of the antennas is not | Check the antenna connections | |
diversity display (I or II) appears on | connected correctly |
| |
the display panel |
|
| |
|
|
|
If problems occur that are not listed in the above table or if the problems cannot be solved with the proposed solutions, please contact your local Sennheiser agent for assistance.
63