Using Other Manufacturer’s Mounts

VERTICAL

MOUNTING

CONFIGURATION

SWIVEL

ADJUSTMENT

SCREW

XMC10

CRADLE

ASSEMBLY

PLASTIC LINER

AND ADHESIVE SWIVEL

BACKINGBRACKET

SIDE (HORIZONTAL) MOUNTING CONFIGURATION

SCREW HOLES

(2)FOR DIRECT HARD MOUNTING

-9-

3.Using Other Manufacturer’s Mounts

The XMC10 Cradle can also be installed using other manufacturer’s mounts; the mounting plate provisions on the rear and bottom of the cradle provideyou with two mounting options within the vehicle using various vehicle-specific aftermarket brackets.

4.Installing the Xpress XM® Receiver into the Cradle Install the Receiver as follows:

a.After making sure the connectors and guide pin hole are properly lined up, gently lower the Xpress XM® Receiver into the cradle and press down on the Xpress XM® Receiver to mate the connectors together. The raised detent on the cradle will enter the notch on the rear of the Receiver, indicating the Xpress XM® is properly seated.

b.The Xpress XM® Receiver should now be secured in the cradle

128-7472

9 of 16