4.1 Searching broadcasting services 27
When you switch to an service, if the service is provided by a satellite other than current one, it will take longer time than usual because the antenna has to turn to its position.
To use the DiSEqC 1.2, select the Installation > Motorized DiSEqC 1.2 menu. You should see a screen like the left figure.
At first you have to set the Mo- torized DiSEqC 1.2 option to Enable.
To get the correct position of your desired satellite, perform the following steps:
1.Choose your desired satellite at the Satellite Name op- tion.
2.Set the DiSEqC Command Mode to User.
3.Select the Goto option at the Motor Control menu. Then the antenna will turn toward your selected satellite with the position data that the digital receiver has.
4.If the receiving quality, which is displayed at the bottom right of the screen, is not good, tune the antenna finely with the options of the Movement menu. If you select the 2(E) movement option, the antenna will move to the east by two degrees. At this time you had better check the receiving quality of every transponder and choose the best one at the Transponder (or Frequency) option. It will be helpful to your fine tuning.