Installation of the Control unit
■ Installing location | Dashboard |
Place the Control unit on the passenger’s seat or stick the Velcro tape (large A) to the center console.
∗Before sticking the Velcro tape, clean the sticking surface.
∗Choose a location where the driving of a car is not hindered and the reception of the signals from the remote control unit is ensured as well (Figure 2).
Fig 2
Velcro tape (large A)
English
■How to install the Control unit
When installing the Control unit, use the Velcro tape (small B) to secure it (Figure 3).
∗Before sticking the Velcro tape, clean the sticking surface.
∗To secure the cord, use the cord holder by sticking it to the center console, etc. (Figure 4).
Notes:
Do not leave the Control unit at a location (dash- board, etc.) where the temperature goes high. Oth- erwise, the unit may be deformed or damaged.
Velcro tape (small B)
Control unit
Fig 3
UP |
160 |
3 9 |
2 |
55 |
117 |
How to install the Control unit (in case of using screws)
∗Screws are not enclosed with unit.
∗Be sure to check the screw length. (M3 x 6mm MAX)
Cord holder
Fig 4 
DSC920S 9