IBM T400S, T410SI manual Numeric error codes continued, Hardware Maintenance Manual

Table 2. Numeric error codes (continued)

Symptom or error	FRU or action, in sequence
0196	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware removed
		password, and select Password ➙ Security Chip
		➙ Clear Security Chip to clear this error.
	2.	Security chip.
	3.	System board.
0197	The remote configuration for the security chip has
Invalid remote change requested.	failed. Confirm the operation and try again.
0199	1.	Run BIOS Setup Utility, and then save the current
System Security— Security password retry count
exceeded.		setting by pressing F10.
	2.	System board.
01C8	1.	Remove either a Mini-PCI Card or a modem
Two or more modem devices are found. Remove all but
one of them. Press <Esc> to continue.		daughter card. Otherwise, press Esc to ignore
		the warning message.
	2.	System board.
01C9	1.	Remove either a Mini PCI Ethernet card or an
Two or more Ethernet devices are found. Remove all but
one of them. Press <Esc> to continue.		Ethernet daughter card. Otherwise, press Esc to
		ignore the warning message.
	2.	System board.
01C9	1.	Remove the Ethernet device that you installed; or
More than one Ethernet devices are found. Remove one
of them. Press <Esc> to continue.		press Esc to ignore the warning message.
	2.	System board.
01CA	1.	Remove the wireless LAN device that you
More than one Wireless LAN devices are found. Remove
one of them.		installed.
	2.	System board.
0200	1.	Reseat the hard disk drive.
Hard disk error—The hard disk is not working.
	2.	Load Setup Defaults in BIOS Setup Utility.
	3.	Hard disk drive.
	4.	System board.
021x	Run interactive tests of the keyboard and the auxiliary
Keyboard error.	input device.
0220	Load Setup Defaults in BIOS Setup Utility.
Monitor type error—Monitor type does not match the one
specified in CMOS.
0230	System board.
Shadow RAM error—Shadow RAM fails at offset nnnn.
0231	1.	DIMM.
System RAM error—System RAM fails at offset nnnn.
	2.	System board.
0232	1.	DIMM.
Extended RAM error— Extended RAM fails at offset nnnn.
	2.	System board.

52Hardware Maintenance Manual