IBM T400S, T410SI manual Numeric error codes

Note: For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for that device.

Numeric error codes

Table 2. Numeric error codes

Symptom or error	FRU or action, in sequence
0175	System board.
Bad CRC1, stop POST task—The EEPROM checksum is
not correct.
0176	1.	Run BIOS Setup Utility and save the current setting
System Security—The system has been tampered with.
		by pressing F10.
	2.	System board.
0177	System board.
Bad SVP data, stop POST task—The checksum of the
supervisor password in the EEPROM is not correct.
0182	1.	Run BIOS Setup Utility. Press F9, and Enter to load
Bad CRC2. Enter BIOS Setup and load Setup
defaults.—The checksum of the CRS2 setting in the		the default setting. Then save the current setting by
EEPROM is not correct.		pressing F10.
	2.	System board.
0185	1.	Run BIOS Setup Utility. Press F9, and Enter to load
Bad startup sequence settings. Enter BIOS Setup and
load Setup defaults.		the default setting. Then save the current setting by
		pressing F10.
0187	System board.
EAIA data access error—The access to EEPROM is failed.
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190	System board.
Critical low-battery error
0191	System board.
System Security—Invalid Remote Change requested.
0192	1.	Charge the battery pack.
System Security— Embedded Security hardware tamper
detected.	2.	Battery pack.
0193	Enter the supervisor password.
RF antenna has been removed
0194	Enter the supervisor password.
The computer has been carried through a security gate
0195	1.	Enter BIOS Setup Utility by entering supervisor
Security hardware tamper detected
		password, and select Password ➙ Security Chip
		➙ Clear Security Chip to clear this error.
	2.	Security chip.
	3.	System board.

Chapter 4. Related service information 51