IBM T400S, T410SI manual Error messages, Numeric error codes continued

Table 2. Numeric error codes (continued)

Symptom or error	FRU or action, in sequence
2010	Inform the following information to the customer: If
Warning: Your internal hard disk drive (HDD) may not	in the primary bay the customer is using a non-IBM
function correctly on this system. Ensure that your HDD	or non-Lenovo hard disk drive (HDD), or an old
is supported on this system and that the latest HDD	generation IBM HDD which is not supported by this
firmware is installed.	system, with the risk in mind, the customer can still
	use it by pressing ESC. If in the primary drive bay the
	customer is using a supported IBM/Lenovo HDD with
	an old firmware, the customer needs to update its
	firmware to the latest. The latest version is available at
	http://www.lenovo.com/support
201x	Inform the following information to the customer: If the
The solid state drive you have installed has not passed	customer is using a non qualified SSD which is not
qualification for use in this computer. Using this drive may	supported by this system, with the risk in mind, the
cause compatibility issues and potential issues with data	customer can still use it by pressing ESC. Location of the
integrity, including data loss. Press <Esc> to continue.	SSD is designated as below:
		2010: HDD0 (in HDD slot-0)
		2011: HDD1 (in HDD slot-1)
		2012: Ultrabay with HDD adapter
2100	1.	Reseat the hard disk drive.
Initialization error on HDD0 (Main hard disk drive)
	2.	Main hard disk drive.
	3.	System board.
2102	1.	Reseat the hard disk drive.
Initialization error on HDD1 (Ultrabay hard disk drive)
	2.	Ultrabay™ hard disk drive.
	3.	System board.
2110	1.	Reseat the hard disk drive.
Read error on HDD0 (Main hard disk drive)
	2.	Main hard disk drive.
	3.	System board.
2112	1.	Reseat the hard disk drive.
Read error on HDD1 (Ultrabay hard disk drive)
	2.	Ultrabay hard disk drive.
	3.	System board.

Error messages

Table 3. Error messages

Symptom or error	FRU or action, in sequence
Device address conflict.	1.	Load “Setup Defaults” in the BIOS Setup Utility.
	2.	Backup battery.
	3.	System board.
Allocation error for device.	1.	Load “Setup Defaults” in the BIOS Setup Utility.
	2.	Backup battery.
	3.	System board.
Failing bits: nnnn.	1.	DIMM.
	2.	System board.

Chapter 4. Related service information 55