Bosch Appliances PLE-2MA120-US, PLE-2MA240-US manual Connecting emergency telephone lines

Page 21

Plena Mixer Amplifier Installation and User Instructions Connections and settings

4.1.5.2Connecting telephone lines

Connect the telephone lines as shown in figure 4.5.

Caution

A connection to a telephone network must always be made via a telephone coupler that provides adequate isolation between the telephone network (PBX) and the Plena system. The telephone coupler must also meet all relevant requirements for this type of communication equipment as imposed by law and/or responsible telecommunication organizations in the country of use. Never try to make a direct connection between the telephone network and the mixer amplifier.

en 19

figure 4.5: Connecting emergency telephone lines

Bosch Security Systems 2007-10 PLE-2MA120-US, PLE-2MA240-US en

Image 21
Contents Plena Mixer Amplifier Alerts on the apparatus Important safeguardsPage Thank you for choosing a Bosch Security Systems product Table of contents Operation Introduction Conversion of units of mass Conversion tablesDescription Contents of boxPlena product range Plena Mixer AmplifierSchematic overview of the Plena Mixer Amplifier Controls, connectors and indicators Front panelPlena PLE-WP2Z3S wall panel Rear panel Rear panel Intentionally left blank Install unit in rack optional InstallationCheck settings/connections Unpack unitIntentionally left blank Connections and settings Connecting inputsDC supply battery Priority microphone input Euro connector with triggerAdditional microphones inputs 3 through Secondary microphone inputEmergency inputs Connecting 70 Volt input signalConnecting emergency telephone lines Music source inputs Connecting music source inputsZone 1 Connecting outputsCall only Music onlyConstant voltage loudspeakers Connecting speakersRear panel settings Unit settingsRotary controls Pin settings and labelling Intentionally left blank Switch off Switch on and offSwitch on OperationMicrophone/line controls Music controlsTone control Master volume control Output controlsZone selection Intentionally left blank Electrical Technical dataEnvironmental MechanicalPage For more information visit