Bosch Appliances PLE-2MA240-US manual Thank you for choosing a Bosch Security Systems product

Page 4

Plena Mixer Amplifier Installation and User Instructions Important safeguards

en 4

American Users

Note

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Canadian Users

Note

This Class B digital device complies with Canadian ICES-003.

Cet appareil numérique de classe B est conforme à la norme NMB-003 du Canada.

Thank you for choosing a Bosch Security Systems product!

Bosch Security Systems 2007-10 PLE-2MA120-US, PLE-2MA240-US en

Image 4
Contents Plena Mixer Amplifier Important safeguards Alerts on the apparatusPage Thank you for choosing a Bosch Security Systems product Table of contents Operation Introduction Conversion tables Conversion of units of massContents of box DescriptionPlena product range Plena Mixer AmplifierSchematic overview of the Plena Mixer Amplifier Front panel Controls, connectors and indicatorsPlena PLE-WP2Z3S wall panel Rear panel Rear panel Intentionally left blank Installation Install unit in rack optionalCheck settings/connections Unpack unitIntentionally left blank Connecting inputs Connections and settingsDC supply battery Euro connector with trigger Priority microphone inputSecondary microphone input Additional microphones inputs 3 throughConnecting 70 Volt input signal Emergency inputsConnecting emergency telephone lines Connecting music source inputs Music source inputsConnecting outputs Zone 1Call only Music onlyConnecting speakers Constant voltage loudspeakersUnit settings Rear panel settingsRotary controls Pin settings and labelling Intentionally left blank Switch on and off Switch offSwitch on OperationMusic controls Microphone/line controlsTone control Output controls Master volume controlZone selection Intentionally left blank Technical data ElectricalMechanical EnvironmentalPage For more information visit