Bosch Appliances PLE-2MA120-EU manual Rear panel

Page 10

Plena Mixer Amplifier Installation and User Instructions Description

en 10

2.4.3Rear panel

See figure 2.3 for an overview of the connectors and switches:

1 Cooling fan.

Note

Always allow adequate space at the rear of the unit for ventilation.

2Microphone/line 1 input, XLR connector - DIP switch settings for: chime, PTT (push to talk), mic/line, speech filter, and phantom power (see number 4). Input is wired in parallel with

microphone/line 1, Euro style pluggable screw terminal connector (see number 3).

3Microphone/line 1 input with trigger, Euro style pluggable screw terminal connector - DIP switch settings for: chime, PTT (push to talk), mic/line, speech filter, and phantom power (see number 4).

Input is wired in parallel with microphone/line 1, XLR connector (see number 2).

4 DIP switch for microphone/line 1 and microphone/ line 2 (see numbers 2 and 3, and 5 respectively).

5Microphone/line 2 input, XLR connector - DIP switch settings for speech filter, mic/line, VOX, and

phantom power (see number 4).

6Microphone/line 3 input, XLR connector - DIP switch settings for mic/line, and phantom power

(see number 7).

7 DIP switch for microphone/line 3 and microphone/ line 4 (see numbers 6 and 8 respectively).

8Microphone/line 4 input, XLR connector - DIP switch settings for mic/line, and phantom power

(see number 7).

9 Microphone/line 5 input, XLR connector - DIP switch settings for mic/line, and phantom power (see number 10).

10DIP switch for microphone/line 5 and microphone/ line 6 (see numbers 9 and 11 respectively).

11Microphone/line 6 input, XLR connector - DIP switch settings for mic/line, and phantom power (see number 10).

12Mains voltage switch, C13 - 115/230 VAC 50/60 Hz.

13Tel. emergency/100V input, Euro style pluggable screw terminal connector - VOX function. This input has highest priority.

14Call station input, RJ-45 connector - PLE-2CS or PLE-2CS-MM, chimes are in call station. This input has second highest priority.

15Remote control wall-panel-input, RJ-45 connector. Wall panel incorporates: BGM source selection, and zone on/off control.

16Telephone emergency/100V input volume control - control range -25 dB to 0dB (see number 13).

17Chime volume control for microphone/line input 1 (see numbers 2 and 3).

18Ducking level control for microphone/line inputs 1 and 2 and call stations.

19Music input (number 1 disc), 2x RCA/cinch connectors. Stereo, summed mono.

20Music input (number 2 radio), 2x RCA/cinch connectors. Stereo, summed mono.

21Music input (number 3 auxiliary), 2x RCA/cinch connectors. Stereo, summed mono.

22Pre-out, amp in insert, 2x RCA/cinch connector - can be used for EQ or feedback suppressor.

23Master switch for line out or music (see number 24).

24Music master output, XLR connector - switch setting for line out, or music only (see number 23).

25Outputs and 24 VDC in/out:

Zone 1 output, Euro style pluggable screw terminal connector - 100 V, and 8 Ohm.

Zone 2 output, Euro style pluggable screw terminal connector - 100 V, and 8 Ohm.

Call only, Euro style pluggable screw terminal connector 100 V.

24 VDC in/out:

Input: 24 VDC backup power.

Output: built in charger, maximum 0.5 A. regulated output current. If battery charging is not required, output can be used for volume

overrides or other purposes.

26Mains fuse.

27Earth connection screw.

Note

The unit must be earthed.

28 Mains connector (3-pole).

Bosch Security Systems 2007-10 PLE-2MA120-EU, PLE-2MA240-EU en

Image 10
Contents Plena Mixer Amplifier Important safeguards Table of contents Operation Digital document Intended audience IntroductionPurpose Related documentationConversion tables Conversion of units of massPlena product range Contents of boxDescription Plena Mixer AmplifierSchematic overview of the Plena Mixer Amplifier Front panel Controls, connectors and indicatorsPlena PLE-WP2Z3S wall panel Rear panel Rear panel Intentionally left blank Check settings/connections InstallationInstall unit in rack optional Unpack unitIntentionally left blank Connecting inputs Connections and settingsDC supply battery XLR connector only Priority microphone inputSecondary microphone input Additional microphones inputs 3 throughConnecting 100 Volt input signal Emergency inputsConnecting emergency telephone lines Connecting music source inputs Music source inputsCall only Connecting outputsZone 1 Music onlyConnecting speakers Constant voltage loudspeakersUnit settings Rear panel settingsRotary controls Pin settings and labelling Intentionally left blank Switch on Switch on and offSwitch off OperationMusic controls Microphone/line controlsTone control Output controls Master volume controlZone selection Intentionally left blank Technical data ElectricalMechanical EnvironmentalPage For more information visit