Bosch Appliances PLE-2MA120-EU manual Connecting emergency telephone lines

Page 19

Plena Mixer Amplifier Installation and User Instructions Connections and settings

4.1.5.2Connecting telephone lines

Connect the telephone lines as shown in figure 4.7.

Caution

A connection to a telephone network must always be made via a telephone coupler that provides adequate isolation between the telephone network (PBX) and the Plena system. The telephone coupler must also meet all relevant requirements for this type of communication equipment as imposed by law and/or responsible telecommunication organizations in the country of use. Never try to make a direct connection between the telephone network and the mixer amplifier.

en 19

figure 4.7: Connecting emergency telephone lines

Bosch Security Systems 2007-10 PLE-2MA120-EU, PLE-2MA240-EU en

Image 19
Contents Plena Mixer Amplifier Important safeguards Table of contents Operation Related documentation IntroductionPurpose Digital document Intended audienceConversion of units of mass Conversion tablesPlena Mixer Amplifier Contents of boxDescription Plena product rangeSchematic overview of the Plena Mixer Amplifier Front panel Controls, connectors and indicatorsPlena PLE-WP2Z3S wall panel Rear panel Rear panel Intentionally left blank Unpack unit InstallationInstall unit in rack optional Check settings/connectionsIntentionally left blank Connecting inputs Connections and settingsDC supply battery Priority microphone input XLR connector onlyAdditional microphones inputs 3 through Secondary microphone inputEmergency inputs Connecting 100 Volt input signalConnecting emergency telephone lines Music source inputs Connecting music source inputsMusic only Connecting outputsZone 1 Call onlyConstant voltage loudspeakers Connecting speakersRear panel settings Unit settingsRotary controls Pin settings and labelling Intentionally left blank Operation Switch on and offSwitch off Switch onMusic controls Microphone/line controlsTone control Output controls Master volume controlZone selection Intentionally left blank Electrical Technical dataEnvironmental MechanicalPage For more information visit