LG Electronics warranty Overview, FMA-LG101 Configuration Prerequisites

FMA-LG101 Configuration

Overview

Once you have completed the required steps to set the PC’s network connections, you can update the FMA-LG101 using either the FTG Device Configuration Application software (v5.0.0 or higher) or the FMA- LG101 software web page.

Experienced installers can refer to the FMA-LG101 configuration quick reference overviews below if extended directions are not required. Otherwise, proceed to the appropriate section depending on whether you are using the FTG Device Configuration Application software or the FMA-LG101 software web page.

FMA-LG101 Configuration Prerequisites

•The FMA-LG101 must be installed in the equipment rack prior to configuration (see FMA-LG101 installation and cabling information on previous pages).

•You will need to know the IP address of the FMA-LG101 (see “FMA-LG101 Ethernet Connection/Network Options” on previous page).

Network Ethernet connection: Consult the network administrator to obtain the IP address that has been assigned by a DHCP server to the FMA-LG101.

Direct Ethernet connection: The FMA-LG101 uses its default IP address (10.20.1.120).

•Create a new or identify an existing FMA Configuration (.fma) file to use for updating the FMA-LG101 (see “Creating an FMA Configuration File” on pages 8 and 9, as necessary).

FMA-LG101 Configuration Quick Reference (FTG Device Configuration Application Software)

1.Launch the FTG Device Configuration Application (v5.0.0 or higher), and access the FMA Configuration Utility. *

2.Set the FMA Utility’s IP address.

3.“Write” the appropriate FMA Configuration file to the FMA-LG101.

4.Set the FMA clock. (Note that date and time must be set on the PC running the FTG Device Configuration Application prior to an attempt to set the FMA clock.)

5.Set the FMA broadcast rate.

6.Connect the FMA-LG101 to the RF distribution system as described on page 16.

FMA-LG101 Configuration Quick Reference (FMA-LG101 Software Web Page)

1.Launch a web browser. 

2.Type the appropriate IP address in the browser’s address bar and press Enter.

3.Set the date and time parameters and the broadcast rate, and then update the FMA-LG101.

4.Update the FMA-LG101 with an FMA Configuration file.

5.Connect the FMA-LG101 to the RF distribution system as described on page 16.

*If the configuring PC is running Windows Home Premium software, you must run the FTG Device Configuration Application as an administrative user in order to communicate with and configure the FMA-LG101.

206-4124 13