Pioneer XV-DV250 Resetting the system, Using the language code list, Tuner, Error Messages

08Additional information

Tuner

Problem	Remedy
Considerable noise in	• Connect the AM antenna (refer to the Setup Guide) and adjust the direction
radio broadcasts.	and position for best reception. You may also connect an additional internal
	or external AM antenna (refer to Connecting auxiliary components on
	page 24).
	• Fully extend the FM wire antenna, position for best reception, and secure to
	a wall. You may also connect an outdoor FM antenna (see Connecting external
	antennas on page 25).
	• Turn off or move other equipment that may be causing the noise.
	• The tuning interval is incorrect for your country or region. Try switching the
	tuning interval (frequency step) (see Frequency step setting on page 33).
Auto tuning does not	• The radio signal is weak. Auto tuning will only detect radio stations with a
pick up some stations.	good signal. For more sensitive tuning, connect an outdoor antenna.

Error Messages

Message	Description
REC MODE	• An operation is prohibited because the Recording Mode is on (page 24).
SND DEMO	• The sound demo is on. See General in Troubleshooting on page 34.
CANNOT	• An operation is prohibited because headphones are connected, or TEST
	TONE is pressed during disc playback.
STEREO	• An operation is prohibited because the DVD/CD function isn’t selected.
TRAY LOCK	• The tray lock is on. Contact your Pioneer authorized dealer for instructions.
MUTING	• An operation is prohibited because the sound is muted (press MUTE).
EEP ERR	• Contact your Pioneer authorized service center or your dealer for servicing.
EXIT	• Appears when a menu is automatically exited after a set period of inactivity.

Resetting the system

Use this procedure to reset all system settings to the factory default.

1 Switch the system on.

2 Press STANDBY/ON while holding down the front panel FM/AM button.

The next time you switch on, all the system settings should be reset.

36

Using the language code list

Some of the language options (see Language settings on page 21) allow you to set your preferred language from any of the 136 languages in the following Language code list.

1	Select ‘Other Language’.
2	Use	(cursor left/right) to select
either a code letter or a code number.
3	Use	(cursor up/down) to select a

code letter or a code number.

See the Language code list (next page) for a complete list of languages and codes.

En