Pioneer VSX-01THX operating instructions Multi Channel Input Setup, Zone Audio Setup

Other Settings

Multi Channel Input Setup

You can adjust the level of the subwoofer for a multi- channel input. Also, when the multi-channel input is selected as an input source, you can display the video images of other input sources. In the Multi Channel Input Setup, you can assign a video input to the multi-channel input.

1Select ‘Multi Ch In Setup’ from the Other Setup menu.

7.Other Setup

a . Multi Ch In Setup

b . ZONE Audio Setup

c . SR+ Setup

d . HDMI Control Setup

e . OSD Adjustment

:Return

2Select the ‘SW Input Gain’ setting you want.

•0dB – Outputs sound of the subwoofer at the level originally recorded on the source.

•+10dB – Outputs sound of the subwoofer at the level increased by 10 dB.

7a.Multi Ch In Setup

SW Input Gain	0dB
Video Input	[ BD ]

:Finish

3Select the ‘Video Input’ setting you want. When the multi-channel input is selected as an input source, you can display the video images of other input sources. The video input can be selected from the following: DVD, BD, TV, DVR 1, DVR 2, VIDEO.

7a.Multi Ch In Setup

SW Input Gain	[ 0dB ]
Video Input
	BD

:Finish

4When you’re finished, press RETURN. You will return to the Other Setup menu.

10

ZONE Audio Setup

If you’ve made MULTI-ZONE connections (see MULTI- ZONE listening on page 61) you may need to specify your volume setting.

1Select ‘ZONE Audio Setup’ from the Other Setup menu.

7.Other Setup				7b.ZONE		Audio	Setup
				ZONE		2 Volume Level
	a . Multi	Ch In	Setup					Variable
	b . ZONE Audio Setup
	c . SR+	Setup
	d . HDMI Control Setup
	e . OSD	Adjustment
				Be	careful of		loud
				volume		when	"Fixed"
				is	selected.
			:Return					:Finish

2Select the volume level setting.1

•Variable – Use this setting if you’ve connected a power amplifier in the sub room (this receiver is simply being used as a pre-amp) and you will be using this receiver’s controls to adjust the volume.

•Fixed – Use this setting if you’ve connected a fully integrated amplifier (such as another Pioneer VSX receiver) in the sub room and want to use that receiver’s volume controls. (This setting is not available if the surround back system setting is set to ZONE 2.)

With the Fixed setting, the source is sent from this receiver at maximum volume, so make sure the volume is quite low in the sub zone at first, and then experiment to find the correct level.

3When you’re finished, press RETURN. You will return to the Other Setup menu.

Note

1 If you selected ZONE 2 in the Surround back speaker setting on page 41, you won’t be able to change the volume level.

71

En