Black plate (18,1)
Section
02Operating this unit
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band
Level (dB)
Q=2N Q=2W
Center frequency Frequency (Hz)
1Press AUDIO and hold until frequency and the Q factor (e.g.,
2Press AUDIO to select the band for ad- justment from among low, mid and high.
3Press c or d to select the desired fre- quency.
Low:
Mid:
High:
4Press a or b to select the desired Q fac-
tor.
Note
If you make adjustments, CUSTOM curve is up- dated.
Adjusting loudness
Loudness compensates for deficiencies in the low- and
1Press AUDIO to select LOUDNESS.
2Press a to turn loudness on. Loudness level (e.g., LOUDNESS MID) ap-
pears in the display.
# To turn loudness off, press b.
3Press c or d to select a desired level. LOW
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off.
1 Press SW to select SUBWOOFER.
#You can also select the subwoofer setting menu by pressing AUDIO on the unit.
2Press a to turn subwoofer output on. SUBWOOFER NOR appears in the display.
Subwoofer output is now on.
# If the subwoofer output phase has been set to
the reverse, SUBWOOFER REV will be displayed.
# To turn subwoofer output off, press b.
3Press c or d to select the phase of sub- woofer output.
Press c to select reverse phase and REV ap- pears in the display. Press d to select normal phase and NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad- just the
1 Press SW to select SUBWOOFER.
#You can also select the subwoofer setting menu by pressing AUDIO on the unit.
#When the subwoofer output is on, you can se- lect SUBWOOFER (subwoofer setting).
2Press c or d to select
Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.
3Press a or b to adjust the output level of the subwoofer.
+6 to
18 En