Installation
2. Install side brackets. (Fig. 7)
7When the installation space is not very deep
When installing in a shallow space, secure with side brackets (small). In this case, stick conceal tape on parts that protrude from the dashboard.
2. Fastening the unit to the factory radio mounting bracket. |
(Fig. 11) (Fig. 12) |
<ENGLISH>
Installing the Voice Guidance Speaker
Precaution:
Side bracket
Flush surface screw (5 ⋅ 6 mm)
Fig. 7
Dashboard
182
53
Holder
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Conceal tape
Select a position where the screw holes of the bracket and the screw holes of this product |
become aligned (are fitted), and tighten the screws at 2 places on each side. Use any of bind- |
ing screws (4 ⋅ 3 mm), binding screws (5 ⋅ 6 mm) or flush surface screws (5 ⋅ 6 mm), |
depending on the shape of the screw holes in the bracket.
*1 Use binding screws (4 ⋅ 3 mm) only.
*1 *1
•Do not install on the dashboard where it may be subjected to direct sunlight. High temperatures may result in damage to the unit.
•Install within the transmission range of the remote control signal.
Stick the supplied velcro tapes to both the back of the voice guidance speaker and center console, and attach them.
Voice guidance speaker
3.Fastening the unit. (Fig. 8)
As a rule, secure with side brackets (large).
Attach screw
Velcro tape (rough surface)
Dashboard
182
53
Side bracket (large)
Holder
After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.
(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)
Rubber bush
Screw
Attach screw
Side bracket (small)
Fig. 9
DIN Rear-mount
Installation using the screw holes on the side of the unit
1. Remove the frame. (Fig. 10)
Frame
Fig. 11
Screw
Dashboard or Console
Factory radio mounting bracket
Fig. 12
Velcro tape (soft surface)
Fig. 13
Fig. 8
Pull out to remove the frame.
(When reattaching the frame, point the side with a groove downwards and attach it.)
Fig. 10