Installation
INSTALLATION CAUTION
1.Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly.
2.Use only the parts included with the unit to ensure proper installation. The use of un- authorized parts can cause mal functions.
3.Consult with your nearest dealer if install- ation requires the drilling of holes or other modifications of the vehicle.
4.Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop.
5.If installation angle exceeds 30° from horizontal, the unit might not give its
optimum performance.
6.Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.
7.Be sure to remove the front panel before installing the unit.
Installation with the half sleeve
After inserting the half sleeve into the dashboard, select the appropriate tab according to the thickness of the dashboard mterial and bend them inwards to secure the holder in place.
Dashboard
182
Screw
111
Half
Sleeve
Attach the trim ring
Trim ring
Installation using the screw holes on the side of the unit
Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted) and tighten the screws at 2 places on each side.
Factory
radio Screw mounting
bracket
Hook
Screw
Hook
Dashboard or console
Note: The outer trim ring,and
Note: The mounting box, metal half sleeve, hook & screws are not included in the packnig.
RESETTING THE UNIT
After releasing the front panel, use a stick or any
Reset Button
E - 3