Controls and Features

Front

<Front Panel>

VOLUME	PHASE CHROMA	UNDER	PULSE	COLOR	BLUE
VOLUME	PHASE CHROMA	BRIGHT CONTRAST SCAN	CROSS	OFF	CHECK
					POWER
		—A	EXT	NTSC	4:3
		_B	SYNC	PAL	16:9
V.HOLD	PAL	NTSC			ON OFF

		11	12	13	14
VOLUME	PHASE CHROMA	UNDER	PULSE	COLOR	BLUE
VOLUME	PHASE CHROMA	BRIGHT CONTRAST SCAN	CROSS	OFF	CHECK
					POWER
		A	EXT	NTSC	4:3
		B	SYNC	PAL	16:9
V.HOLD	PAL	NTSC			ON	OFF
4	5	6	7	8	9	10

1 Tally lamp

Indicates that a control signal is being received. The tally lamp functions when the control signal is input to the TALLY/REMOTE terminal on the rear panel.

2 Speaker

A built-in speaker is located inside the left side panel.

6 VIDEO A/B switch

Select the video signal input to the video input terminals on the rear panel.

A (—) :Selects the video signal input to VIDEO A terminal.

B (_) : Selects the video signal input to VIDEO B terminal.

3 VOLUME control

Adjusts the speaker volume.

4 V.HOLD control

Use a small-bladed screwdriver to adjust the image’s vertical stability.

5 Picture control section

PHASE, CHROMA, BRIGHT and CONTRAST controls are available.

The standard setting mode can be obtained by setting each control to the center click position. To adjust a setting, insert a small-bladed screwdriver into the space around the knob and turn it to the desired position. When adjusting, use the small-bladed screwdriver and insert it into the control hole around the required control knob.

PHASE control

Adjusts picture hue.

CHROMA control

Adjusts picture color density.

BRIGHT control

Adjusts picture brightness.

CONTRAST control

Adjusts picture contrast.

Note:

*VIDEO B terminals include both Y/C (S-Video) and composite VIDEO terminals. Y/C inputs have priority.

7 EXT SYNC switch

Selects internal sync or external sync.

When using with the external sync, input the sync signal to the EXT SYNC terminal on the rear panel.

(—) :Internal sync

(_) : External sync

8 NTSC/PAL switch

Selects the NTSC or PAL color system.

NTSC (—) :For NTSC color system.

PAL (_) : For PAL color system.

9 4 : 3/16 : 9 switch

Selects the aspect ratio (4:3 or 16:9) of the picture displayed on the screen.

(—) : 4:3

(_) : 16:9

Note:

*When a 4:3 picture is viewed in the 16:9 mode, the size of the image is reduced vertically.

Notes:

*The PHASE control is effective only in the NTSC color system mode.

*The standard CHROMA setting can be adjusted to suit the NTSC or PAL color system.

10 POWER switch/POWER indicator

Press this switch to turn the power on or off.

ON (_) : Power is turned on and the power indicator lights.

OFF (—) :Power is turned off and the power indicator goes off.

Note:

*If the battery expires while the monitor is operated with DC power supply (the voltage level drops), the green indicator changes to orange, then to red. When the POWER indicator changes to red, the power automatically goes off. Make sure you switch off the power before replacing the battery.

(continued on the next page =)