Seagate ST19101N/W/WC/WD/DC Electromagnetic compliance for the European Union, Australian C-Tick

Page 11

Cheetah 9 Installation Guide, Rev. B

9

Electromagnetic compliance for the European Union

If this model has the CE Marking it complies with the European Union requirements of the Electromagnetic Compatibility Direc- tive 89/336/EEC of 03 May 1989 as amended by Directive 92/ 31/EEC of 28 April 1992 and Directive 93/68/EEC of 22 July 1993.

Australian C-Tick

If this model has the C-Tick Marking it complies with the Austra- lia/New Zealand Standard AS/NZS3548 1995 and meets the Electromagnetic Compatibility (EMC) Framework requirements of Australia’s Spectrum Management Agency (SMA).

Image 11

Contents ST19101N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 9 Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 9 Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionSeagate.com Online servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersGeneral description Drive characteristics Additional drive characteristics +12V +5V Voltage regulation ± 5% DC power requirements Amps ST19101 WC models WD, DC modelsDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Abbildung 4. Empfohlener Luftstromverlauf Suggested air flowInstallation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage Pin Gleichstrom Pin PowerHinweis Cheetah 9 Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveSetting the Scsi ID on model N drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Jumper options Applicable jumper optionsDrive Active LED indicator connections Drive Active indicatorPage Page