Seagate ST19101N/W/WC/WD/DC Setting the Scsi ID jumpers, Setting the Scsi ID on model N drives

Page 41

Cheetah 9 Installation Guide, Rev. B

39

N drives

Setting the SCSI ID jumpers

Use the J6 connector to set the SCSI ID (see Figure 7). To change the SCSI ID, install jumpers on the appropriate pins as shown in the illustration.

Jumper Plug	J2
Jumper Plug
(enlarged to
show detail)		Pin 1	J6
		Pin 1
		End
		End
	J6 [4]	Pin 1
		Pin 1

SCSI ID = 0 (default)

SCSI ID = 1

SCSI ID = 2

SCSI ID = 3

SCSI ID = 4

SCSI ID = 5

SCSI ID = 6

SCSI ID = 7

Figure 7. Setting the SCSI ID on model “N” drives

Image 41

Contents ST19101N/W/WC/WD/DC Contents Preface Electrostatic discharge protection Important safety information and precautions Cheetah 9 Installation Guide, Rev. B Wichtige Sicherheitshinweise Cheetah 9 Installation Guide, Rev. B Page Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionSeagate.com Online servicesSeagate CompuServe forum SeaFAX FAX servicesSeagate technical support Direct-support servicesManufacturer’s representatives Customer service centersGeneral description Drive characteristics Additional drive characteristics +12V +5V Voltage regulation ± 5% DC power requirements Amps ST19101 WC models WD, DC modelsDimensions of the drive General information Drive modelsScsi ID jumpers Drive termination Circuits and data path widths Terminator powerCable characteristics for single-ended circuits Pin I/O connection to drive Multiple drive connection to host adapter Multiple-drive connection to host adapter Scsi I/O Providing adequate cooling Kühlung des Systems Abbildung 4. Empfohlener Luftstromverlauf Suggested air flowInstallation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesPage Pin Gleichstrom Pin PowerHinweis Cheetah 9 Installation Guide, Rev. B Mounting configuration dimensions Quick reference desktop system notes Formatting the driveSetting the Scsi ID on model N drives Setting the Scsi ID jumpersTerminating the drive Terminating the driveSetting terminator power jumpers Additional jumper options Other applicable jumper optionsWD drives Model W and WD drive alternate ID select and LED connection Terminating the drive W model shown Drive Front Other option jumpers are available as illustrated below WC/DC drives Jumper options Applicable jumper optionsDrive Active LED indicator connections Drive Active indicatorPage Page